2025 FDOT Earthwork 2
Standard Proctor - Correct Answer-protor typically used for embankment material.
AASHTO T-99
Lift - Correct Answer-6inches of compacted material cor full width.
2 pounds per cubic feet - Correct Answer-comparison difference for gages of same
manufacturers
3 pounds per cubic feet - Correct Answer-comparison difference for gages of different
manufacturers.
bleeding - Correct Answer-when moisture is drawn up by capillary action to the surface
of material being compacted
muck - Correct Answer-A-8 Material
LBR - Correct Answer-Strength test of material based on standardized 800 psi
Select - Correct Answer-Material that can be used anywhere in the the embankment
one - Correct Answer-number of density log books per contact
verification - Correct Answer-testing done by department
dry - Correct Answer-blank density is the weight of solid should
lot - Correct Answer-a single lift of finished material
cover zone - Correct Answer-area from the bottom of the pipe to 12 inches above
resolution - Correct Answer-testing to resolve QC & VT differences
High Plastic - Correct Answer-Material with LL greater than 50
Wet Density - Correct Answer-weight of soil and water
Modified Proctor - Correct Answer-Proctor usually used for subgrade and base. FM1-
T180
control line - Correct Answer-set by normal shoulder points
Standard Proctor - Correct Answer-protor typically used for embankment material.
AASHTO T-99
Lift - Correct Answer-6inches of compacted material cor full width.
2 pounds per cubic feet - Correct Answer-comparison difference for gages of same
manufacturers
3 pounds per cubic feet - Correct Answer-comparison difference for gages of different
manufacturers.
bleeding - Correct Answer-when moisture is drawn up by capillary action to the surface
of material being compacted
muck - Correct Answer-A-8 Material
LBR - Correct Answer-Strength test of material based on standardized 800 psi
Select - Correct Answer-Material that can be used anywhere in the the embankment
one - Correct Answer-number of density log books per contact
verification - Correct Answer-testing done by department
dry - Correct Answer-blank density is the weight of solid should
lot - Correct Answer-a single lift of finished material
cover zone - Correct Answer-area from the bottom of the pipe to 12 inches above
resolution - Correct Answer-testing to resolve QC & VT differences
High Plastic - Correct Answer-Material with LL greater than 50
Wet Density - Correct Answer-weight of soil and water
Modified Proctor - Correct Answer-Proctor usually used for subgrade and base. FM1-
T180
control line - Correct Answer-set by normal shoulder points
