CDX-ASE Engine Repair Chapter 26 Test
Questions Fully Solved.
A liberal amount of bearing assembly lube should be placed on both halves of the ________ bearing
inserts and the journal on the crankshaft. - Answer Connecting rod
After the main bearing inserts are installed, the ________ is installed, and then the clearance between
the crankshaft journals and the main bearings is measured. - Answer Crankshaft
During the engine rebuilding process, all of the crankshaft journals should have been inspected and
________ if necessary. - Answer Reground
Engine reassembly is being discussed. Technician A says that the engine should be painted to protect it
from rust and corrosion. Technician B says that the engine can be painted before or after installing the oil
gallery and any soft plugs. Who is correct? - Answer Both Technician A and Technician B
For a ________ balancer, do not hammer it onto the crank. - Answer Press-on
Identify the correct statement with regard to timing chains: - Answer Timing chains last much longer
than timing belts.
Immediately after installing the timing belt/chain and related parts, Technician A says install the front
timing chain/belt cover to keep out foreign materials. Technician B says rotate the crankshaft two
complete revolutions by hand and recheck the timing marks and belt/chain tension. Who is correct? -
Answer Technician B
Most engines use a _______ gasket that does not require sealant on either side. - Answer Composition-
type
Once you have done the engine assembly test buildup, and ensured that all the parts work fine, which of
the following do you NOT do before the final assembly? - Answer Perform a test to check if the
components are working properly.
Questions Fully Solved.
A liberal amount of bearing assembly lube should be placed on both halves of the ________ bearing
inserts and the journal on the crankshaft. - Answer Connecting rod
After the main bearing inserts are installed, the ________ is installed, and then the clearance between
the crankshaft journals and the main bearings is measured. - Answer Crankshaft
During the engine rebuilding process, all of the crankshaft journals should have been inspected and
________ if necessary. - Answer Reground
Engine reassembly is being discussed. Technician A says that the engine should be painted to protect it
from rust and corrosion. Technician B says that the engine can be painted before or after installing the oil
gallery and any soft plugs. Who is correct? - Answer Both Technician A and Technician B
For a ________ balancer, do not hammer it onto the crank. - Answer Press-on
Identify the correct statement with regard to timing chains: - Answer Timing chains last much longer
than timing belts.
Immediately after installing the timing belt/chain and related parts, Technician A says install the front
timing chain/belt cover to keep out foreign materials. Technician B says rotate the crankshaft two
complete revolutions by hand and recheck the timing marks and belt/chain tension. Who is correct? -
Answer Technician B
Most engines use a _______ gasket that does not require sealant on either side. - Answer Composition-
type
Once you have done the engine assembly test buildup, and ensured that all the parts work fine, which of
the following do you NOT do before the final assembly? - Answer Perform a test to check if the
components are working properly.
