RED SEAL #201-200-Exam Study
Material + Questions 100% Correct
Solutions
Deburr and bevel.
Which of the following should the pipe end from a CPVC pipe to
be prepared?
Obtain a permit, install, test and
inspect
What sequence of plumbing procedures applies before a
plumbing system is covered?
silver braze
Medical gas piping is most often joined by:
3
When installing lines for gas appliances the depth of dirt or drip pocket must be
a minimum of
___inches or the diameter of the pipe it serves whichever is greater
US gallons per minute.
The acronym US gpm stands for:
supply
What type of piping sends water through a hot water heater?
low carbon steel
, Which of the following metals is easily cut with oxy-fuel process?
yellow
What colour should the glue be that is used for ABS pipe?
Are used to keep operating pressure
lower than the supply pressure
When flow controls are installed on gas piping, they _____________.
equal to the maximum pipe movement.
When selecting the proper telescopic expansion joint it is critical that the
axial movement is at least
6
A flat roof measuring 20m by 26m with a horizontal wall on one side
extended up 6m by 20m. Size the circular rain water leader if the local 15
minute rain fall intensity is 24mm?
Continuous rodding.
An underground water service is installed using thrust blocks.
What additional method could be used to restrain the joints?
Underground under a building.
Where is 8 in. Class 1500 non-pressure Asbestos Cement sewer pipe
allowed for installation?
wrot copper
Material + Questions 100% Correct
Solutions
Deburr and bevel.
Which of the following should the pipe end from a CPVC pipe to
be prepared?
Obtain a permit, install, test and
inspect
What sequence of plumbing procedures applies before a
plumbing system is covered?
silver braze
Medical gas piping is most often joined by:
3
When installing lines for gas appliances the depth of dirt or drip pocket must be
a minimum of
___inches or the diameter of the pipe it serves whichever is greater
US gallons per minute.
The acronym US gpm stands for:
supply
What type of piping sends water through a hot water heater?
low carbon steel
, Which of the following metals is easily cut with oxy-fuel process?
yellow
What colour should the glue be that is used for ABS pipe?
Are used to keep operating pressure
lower than the supply pressure
When flow controls are installed on gas piping, they _____________.
equal to the maximum pipe movement.
When selecting the proper telescopic expansion joint it is critical that the
axial movement is at least
6
A flat roof measuring 20m by 26m with a horizontal wall on one side
extended up 6m by 20m. Size the circular rain water leader if the local 15
minute rain fall intensity is 24mm?
Continuous rodding.
An underground water service is installed using thrust blocks.
What additional method could be used to restrain the joints?
Underground under a building.
Where is 8 in. Class 1500 non-pressure Asbestos Cement sewer pipe
allowed for installation?
wrot copper
