CSLB C10 Test 1 (Latest Update) Real
120 Questions and Verified Answers | 100%
Correct | Already Graded A+.
Save
Practice questions for this set
Learn 1 /7 Study with Learn
12'
Choose matching term
What is the minimum working
1 clearance from an electrical panel 2 The symptoms of shock are:
under 600 V?
What would the output be from a
What is the maximum permitted
circuit that draws 60 amps from a
3 4 distance between convenience
480 V circuit if the power factor is
outlets in kitchens?
90%?
Don't know?
,Terms in this set (120)
What is the minimum 36"
working clearance from an
electrical panel under 600
V?
Voltage drop in wire is a Wire gauge, Length of wire, Current flow in the wire
function of:
A 12-volt direct current, 13- 156
watt fluorescent light is
controlled by a photocell.
The average daily on-time
is 12 hours per day. How
many watt-hours are
consumed by the light on
an average day?
Where may you use inside floors and walls
nonmetallic-sheathed
cable?
What is the maximum 12'
permitted distance
between convenience
outlets in kitchens?
The minimum permitted No. 18
size fixture wire is:
What is an Erickson to connect two sections of rigid conduit when one
coupling used for? section cannot be turned
The smallest size No. 8 copper
grounding conductor
permitted for service
entrance is:
, For an electric appliance 25 amps
with a 17.5 A load, the
overcurrent device must
not exceed:
A 5 kW appliance is used $0.35
for 5 hours. At $0.014 per
kWh, the cost of running
the appliance is:
If the plumber general contractor
accidentally cuts installed
wires, to whom should you
report the problem?
What is the maximum 24"
distance to an outlet from
any point along the wall
behind a kitchen counter?
Which of the following enamel
materials is not corrosive?
65 street lights are fed by 35 V
a 2275-volt series circuit.
What is the voltage across
each light?
What do you not take into small portable heating and cooling appliances
consideration when doing
load demand
calculations?
relay coil
The symbol represents a:
120 Questions and Verified Answers | 100%
Correct | Already Graded A+.
Save
Practice questions for this set
Learn 1 /7 Study with Learn
12'
Choose matching term
What is the minimum working
1 clearance from an electrical panel 2 The symptoms of shock are:
under 600 V?
What would the output be from a
What is the maximum permitted
circuit that draws 60 amps from a
3 4 distance between convenience
480 V circuit if the power factor is
outlets in kitchens?
90%?
Don't know?
,Terms in this set (120)
What is the minimum 36"
working clearance from an
electrical panel under 600
V?
Voltage drop in wire is a Wire gauge, Length of wire, Current flow in the wire
function of:
A 12-volt direct current, 13- 156
watt fluorescent light is
controlled by a photocell.
The average daily on-time
is 12 hours per day. How
many watt-hours are
consumed by the light on
an average day?
Where may you use inside floors and walls
nonmetallic-sheathed
cable?
What is the maximum 12'
permitted distance
between convenience
outlets in kitchens?
The minimum permitted No. 18
size fixture wire is:
What is an Erickson to connect two sections of rigid conduit when one
coupling used for? section cannot be turned
The smallest size No. 8 copper
grounding conductor
permitted for service
entrance is:
, For an electric appliance 25 amps
with a 17.5 A load, the
overcurrent device must
not exceed:
A 5 kW appliance is used $0.35
for 5 hours. At $0.014 per
kWh, the cost of running
the appliance is:
If the plumber general contractor
accidentally cuts installed
wires, to whom should you
report the problem?
What is the maximum 24"
distance to an outlet from
any point along the wall
behind a kitchen counter?
Which of the following enamel
materials is not corrosive?
65 street lights are fed by 35 V
a 2275-volt series circuit.
What is the voltage across
each light?
What do you not take into small portable heating and cooling appliances
consideration when doing
load demand
calculations?
relay coil
The symbol represents a:
