Written by students who passed Immediately available after payment Read online or as PDF Wrong document? Swap it for free 4.6 TrustPilot
logo-home
Document preview thumbnail
Preview 3 out of 17 pages
Exam (elaborations)

T4 ASE style questions and answers

Document preview thumbnail
Preview 3 out of 17 pages

T4 ASE style questions and answers

Content preview

T4 ASE style questions and
answers
All of the following names describe air brake reservoirs EXCEPT:
Auxiliary
3 multiple choice options
Technician A says that before a gear-driven air compressor is replaced, the
gear must be timed with the engine prior to installation. Technician B says
that when timing an air compressor gear, the piston in the engine's No. 1
cylinder must be at Top Dead Center. Who is right?
Both A and B
3 multiple choice options
Technician A says most manufacturers recommend checking automatic
slack adjuster internal clutch operation with a torque wrench. Technician B
says if the free stroke is within manufacturer's specifications, but the
applied stroke is not, the problem could be with the automatic slack
adjuster. Who is right?
Technician A
3 multiple choice options
A truck with air brakes takes an inordinate time to build up adequate air
pressure. Oil has been found in the air brake system. Technician A says the
compressor air filter could be clogged. Technician B says the compressor
oil control rings could be worn. Who is right?
Both A and B
3 multiple choice options
All of the following are phases of hydraulic brake ABS control EXCEPT:
Pressure induction
3 multiple choice options
Technician A says automatic slack adjusters improve brake balance and
reduce downtime and maintenance costs. Technician B says manual slack
adjusters provide reduced chamber travel and less air consumption. Who
is right?
Technician A

,When checking an application valve for internal leaks, an ultrasonic leak
detector can be used at which port?
Exhaust Port
3 multiple choice options
The right front wheel of a truck with hydraulic anti-lock brakes locks up
when on a slippery surface. Technician A says the truck could have a
defective wheel sensor. Technician B says the sensor checks for a lock-up
condition and sends a signal to the hydraulic modulator. Who is right?
Both A and B
3 multiple choice options
Technician A says brake shoe oil contamination should be no more than
10% of the lining surface. Technician B says oil contamination can lead to
brake imbalance. Who is right?
Both A and B
3 multiple choice options
Technician A says that Automatic Traction Control (ATC) controls the
engine only. Technician B says that automatic traction control works in
tandem with antilock brakes. Who is right?
Technician B
3 multiple choice options
An air-braked vehicle has lining wear tapered from inboard to outboard.
There also is abrasion on the outer edges of the brake shoes. What
could NOT be the cause?
Weak return springs
3 multiple choice options
When should the air tanks be drained on an air braked vehicle with no air
dryer.
Once a day
3 multiple choice options
The Driver Vehicle Inspect Report (DVIR) should be submitted:
Daily
3 multiple choice options
The minimum suggested lining thickness for drum brakes is:
1/4-in

, 3 multiple choice options
Technician A says coefficient of friction is the amount of heat absorbed
into the drum. Technician B says brake shoes with high coefficient of
friction will slow a truck with less application pressure. Who is right?
Technician B
3 multiple choice options
The driver of a truck with air brakes says it has poor stopping power. Any
of these could be the cause EXCEPT:
The quick release valve exhaust port is plugged
3 multiple choice options
Technician A says disc brake rotor thickness must be measured in several
places on the rotor using a dial indicator. Technician B says the thickness
of disc brake rotors must not vary more than 0.005 in. Who is right?
Technician B
3 multiple choice options
Technician A says the brake ABS is used to control the truck during
deceleration. Technician B says ATC is used to keep loads from shifting.
Who is right?
Technician A
3 multiple choice options
The driver of a truck with hydraulic drum brakes complains that when his
vehicle is unloaded, the rear brakes lock up on moderate to hard braking
application. Which of the following could be the cause?
Defective proportioning valve
3 multiple choice options
Which of the following best describes the operation of an air-operated ABS
system?
Works in tandem with ATC
3 multiple choice options
The driver of an air-braked truck with ABS complains that on a panic stop
in wet weather conditions, the truck's right rear wheel locks up. What
could be the cause?
A defective ABS wheel sensor
3 multiple choice options

Document information

Uploaded on
February 8, 2025
Number of pages
17
Written in
2024/2025
Type
Exam (elaborations)
Contains
Unknown
$15.49

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
BRAINBOOSTERS
4.5
(355)
Sold
783
Followers
257
Items
25928
Last sold
6 days ago



Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions