Dante Certification Level 2 Exam Latest Update All With 280 Questions And Correct Detailed Solutions Just Released This Year

Page 1 of 19



DANTE CERTIFICATION LEVEL 2 EXAM LATEST
UPDATE ALL WITH 280 QUESTIONS AND
CORRECT DETAILED SOLUTIONS JUST
RELEASED THIS YEAR

DANTE CERTIFICATION LEVEL 2 (2ND EDITION)

Question: The Dante clock leader election is an automatic process. However, you can manually
influence which device will win the election. What option would give a device the highest
priority in the election process? - CORRECT ANSWER✔✔Preferred Leader checked.




Question: Suppose a Dante device has one channel and two transmit flows. Can it connect to
three different receiving devices? - CORRECT ANSWER✔✔Yes. Minimum recommended latency
could be as low as 0.5 msec.




Question: Approximately how much bandwidth does a unicast audio flow use? (4-ch, 24-bit,
48kHz, 1msec latency) - CORRECT ANSWER✔✔6Mbps




Question: Dante Controller can apply information in a Dante preset to a device of a different
model. For instance, if a 4-channel 70V amplifier is replaced with an 8-channel model, it could
save the IP settings, device name, as well as channel labels and subscriptions for the first four
channels. - CORRECT ANSWER✔✔True




1
SUCCESS!

,Page 2 of 19


Question: When recalling a Dante Preset, you can choose to recall everything or limit the recall
to specific features and/or specific devices. - CORRECT ANSWER✔✔True




Question: What happens if multiple devices have the Preferred Leader checkbox marked? -
CORRECT ANSWER✔✔Both will be elevated in the clock election process, only one of those two
will be come the clock leader.




Question: When using redundant Dante networks, how do we configure the switches? -
CORRECT ANSWER✔✔The primary and secondary networks must remain in separate broadcast
domains (could be a VLAN) and each network must use separate subnets.




Question: Suppose a Dante device that is chasing an external clock (like word clock or video
sync). What setting must be checked in Dante Controller? - CORRECT ANSWER✔✔In Dante
Controller, make sure the "External Clock" checkbox is marked for this device.




Question: How many audio channels can be contained in a Dante unicast flow? - CORRECT
ANSWER✔✔4




Question: A unicast audio or video subscription: - CORRECT ANSWER✔✔is the default behavior
for Dante devices.




2
SUCCESS!

, Page 3 of 19


Question: Since the beginning of Dante, multicast flows could carry [ __ ] channels per flow.
With newer firmware, some devices can allow up to [ __ ] channels per flow. - CORRECT
ANSWER✔✔8, 64




Question: What protocol is used to synchronize Dante devices across the network? - CORRECT
ANSWER✔✔PTP (Precision Time Protocol)




Question: A unicast subscription is made between two Dante devices. The default latency
settings of the transmitter and receiver are 0.25msec and 0.5msec, respectively. What is the
resulting latency of this stream? - CORRECT ANSWER✔✔.5msec




Question: When a Dante preset is saved, where is the information kept? - CORRECT
ANSWER✔✔Dante Controller writes a text file (XML format) to the computer. This file can be
shared to other users or archived for recall later. When the preset is recalled, Dante Controller
systematically restores settings, one at a time.




Question: Which Dante software supports redundant connections? - CORRECT
ANSWER✔✔Dante Controller




Question: If a Dante transmitter runs out of flows, what should you do to enable all
subscriptions to be made? - CORRECT ANSWER✔✔Flip stream(s) to multicast so it only takes
one flow for multiple destinations.




3
SUCCESS!