Welding Level 2, Module 7 Exam 2025 Questions & Answers with 100% Correct Answers | Verified

A shielding gas can be generated entirely from the ____________________ in the electrode core. (self shielded FCAW-S) - flux If a hard hat is required for the environment, use one that allows the attachment of ____________________. - rear deflector material When preparing to practice welding, set up ____________________ around the welding area. - flash sheids V-groove weld coupons must be beveled at _________to___________degrees for carbon steel or low alloy plate. - 30 to 37 1/2 Slower travel speeds build higher beads with ____________________ penetration. - deeper A ____________________ is the travel angle created when the welding gun is tilted back so that the electrode tip precedes the gun in the direction of the weld. - push angle Changing the extension influences the welding current for low conductivity metal electrodes because it changes the preheating of the electrode caused by the resistance of the electrode to current flow. As the extension increases, preheating of the electrode ____________________. - increases ____________________ is the distance from the insulating nozzle to the end of the electrode. - Stickout When making a termination, the welding codes require that the crater must be filled to the ____________________ of the weld. - full cross section Overlapping beads are made by depositing connective weld beads parallel to one another. The parallel beads overlap, forming a flat surface. This is also called ____________________. - padding