Welding 2, Module 1 Exam 2025 Questions & Answers with 100% Correct Answers | Verified

used on drawings, project specifications, and welding procedure specifications (WPS) to convey the design specifications of welds. - Welding Symbols When the weld symbol is on both ____________of the reference line, the information applies to both sides of the joint or surface to which the arrow is pointing. - the top and the bottom _______________ appear on both sides of the reference line when a double fillet or double groove weld is specified. - Symbols ______________ shows symbols for arrow side, other side, and both sides for fillet and V groove welds. - Figure 7 pictures in book, page 4 If the welds are to be staggered as shown in ________. - Figure 17 (C) book page 8 The fillet weld symbols above and below the reference line are offset, as shown in __________. - Figure 17 (D) book page 8 When the groove weld extends all the way through the joint, as shown in __________, no preparation size needs to be shown. - Figure 19 (A) page 10 book When the groove weld extends ONLY PART of the way through the joint, as shown in _______________, the depth of the groove is shown to the left of the symbol. - Figure 19 (B) page 10, book If a __________ is required, the dimension of a groove weld will be shown inside the symbol. Figure 21 - root opening When the weld indicated by the welding symbol is to be made at a location other than that of the initial construction, a ______________ is placed where the arrow line meets the reference line. - small flag