CDT COMPREHENSIVE EXAM AND PRACTICE
EXAM NEWEST 2025 ACTUAL EXAM COMPLETE
250 QUESTIONS AND CORECT DETAILED
ANSWERS WITH RATIONALES (VERIFIED
ANSWERS) |ALREADY GRADED A+
Overjet is defined as - Answer-horizontal overlap.
What is the MOST likely cause for breaking a
denture reline when removing the cast - Answer-
undercuts were not removed before the cast was
poured
,Distoclusion describes a _______________
occlusion - Answer-class II
The rear most, upper most, midmost position of the
mandible in the articular fossa is - Answer-centric
relation
The bilateral curve in which molars are set is called -
Answer-the Curve of Wilson
Which of the following is most correct when finishing
a partial denture with peripheral borders? - Answer-
The borders should remain unaltered
,What should be used to remove resin flash from the
necks of teeth when finishing the denture? - Answer-
trimming chisel
When using an oxygen torch for casting partial
frames, the torch tip should be - Answer-multi-orifice
with a reducing flame
Why should water be allowed to cover only the base
of the flask while cooling the hydrocolloid during cast
duplication? - Answer-to allow it to cool it from the
bottom upward
, What is the best choice of major connector for a
Class IV maxillary Kennedy case? - Answer-
horseshoe
What is the correct term for describing the diameter
of a metal wire? - Answer-gauge
Which of the following is MOST correct when
polishing a chrome partial denture? - Answer-use
high speed (24,000 rpm) and light pressure
EXAM NEWEST 2025 ACTUAL EXAM COMPLETE
250 QUESTIONS AND CORECT DETAILED
ANSWERS WITH RATIONALES (VERIFIED
ANSWERS) |ALREADY GRADED A+
Overjet is defined as - Answer-horizontal overlap.
What is the MOST likely cause for breaking a
denture reline when removing the cast - Answer-
undercuts were not removed before the cast was
poured
,Distoclusion describes a _______________
occlusion - Answer-class II
The rear most, upper most, midmost position of the
mandible in the articular fossa is - Answer-centric
relation
The bilateral curve in which molars are set is called -
Answer-the Curve of Wilson
Which of the following is most correct when finishing
a partial denture with peripheral borders? - Answer-
The borders should remain unaltered
,What should be used to remove resin flash from the
necks of teeth when finishing the denture? - Answer-
trimming chisel
When using an oxygen torch for casting partial
frames, the torch tip should be - Answer-multi-orifice
with a reducing flame
Why should water be allowed to cover only the base
of the flask while cooling the hydrocolloid during cast
duplication? - Answer-to allow it to cool it from the
bottom upward
, What is the best choice of major connector for a
Class IV maxillary Kennedy case? - Answer-
horseshoe
What is the correct term for describing the diameter
of a metal wire? - Answer-gauge
Which of the following is MOST correct when
polishing a chrome partial denture? - Answer-use
high speed (24,000 rpm) and light pressure
