Proliant Exam
Questions With Reviewed 100%
Correct Detailed Answers
Guaranteed Pass!!
1. Which of the following is the core software application that manages
computer virtualization? - ANSWER HYPERVISOR
2. Swap space or page file is reversed on the? - ANSWER HARD DRIVE
3. Which of the following is a requirement to a server to allow guests to be
installed in a hypervisor host? - ANSWER processors that support
virtualization
4. An administrator needs to deploy 1,000 servers in a short. Of time. Which
of the following deployment methods will expedite the O. S. installations? -
ANSWER use P. X. E. Boot to retrieve and image
5. Which of the following are required characteristics of database servers in
high transaction environments. select three - ANSWER high bandwidth,
higher R. P. M. Drives,
,load balancing
6. A network administrator is installing additional devices on the network.
Currently, the network segment is utilizing all allocated IP addresses. If
there are additional addresses available, which of the following would be
the best for the network administrator to perform to accommodate the
new network devices? - ANSWER increase the size of the D. H. C. P.
scope for the network segment in question
7. Which of the following allows virtual machines to share the N. I. C. of the
host? - ANSWER BRIDGING
8. And administrator is asked to change a configuration using a G. U. I. On a
Windows server, but does not have access to a K. V. M.. which of the
following is the best to make the change? - ANSWER R.D.P.
9. Several of the finance department computers are experiencing timeouts
while in their financial program. The program will not open or close,
however, the previous day the program was running without issues. Which
of the following is the most likely the cause of this problem? - ANSWER
ROGUE PROCESSES
10. A technician is assigned a task to configure a new server with six hard
drives. The senior administrator request the technician utilize the drive for
maximum fault tolerance. Which of the following RAID configurations
should the technician use? - ANSWER RAID 10
11. To read arrays are created from 8 disks. when is created using raid 6, the
other is created using raid 5 with a hot spare. Which of the following is the
, operational difference between these configurations? - ANSWER read
six has the ability to recover from two disks simultaneously failing.
12. A data center technician encounters a power receptacle labeled n. C. M. A.
L5 - 30. which of the following powers is the socket rated for? - ANSWER
115v 30 amp
13. A technician is experiencing overheating on a rack mounted server. After
powering off and removing the cover of the server, a large amount of dust
is noticed on one of the fans. After cleaning out the dust and powering the
server back on, the server is still overheating. Which of the following would
best explain this issue? - ANSWER some of the cooling fans are
defective
14. A technician notices a rack-mounted server is beeping without booting up.
The next step to diagnose this issue would be too? - ANSWER count the
beeps and reference the service manual
15. A server technician has been tasked with purchasing cables and connectors
for a new server room. The server room consists of one switch, two servers,
and one IP telephone. Which of the following types of cable and connectors
should the technician purchase? - ANSWER straight through Ethernet
cable and RJ-45 connectors
16. Which of the following is a basic difference between D. A. S. And N. A. S.? -
ANSWER D. A. S. is directly connected to a server. N. A. S. is connected
via IP networking
, 17. A technician is tasked with providing network-based high-availability to a
pair of identical web servers. Which of the following minimum server N. I.
C. configurations fulfill these requirements? - ANSWER one physical N.
I. C. per server. Each individual N. I. C. configured for Network loading
balancing
18. A system administrator is concerned with employees connecting
removable storage to the server to copy sensitive data. Which of the
following Solutions addresses this concern? - ANSWER disable physical
ports
19. Which of the following is a reason to have a remote code site readily
available in case of a disaster in the primary data center? - ANSWER it
provides a company with a backup location to install the necessary
equipment to restore critical services
20. A server in a small company functions as a print server. suddenly it stop
sending print jobs to the printers. a technician verifies that the printers are
working correctly. Additionally, The Print Spooler had been restarted it and
is running on the server, it is accessible from workstations, and it shows as
being ready to accept print jobs. which of the following has most likely
caused the print server to stop processing print jobs? - ANSWER the
servers hard drive is out of space
21. A mission-critical server has faulted with a dead 66 megahertz 3.3 V PCI - x
network interface card. the system administrator has been directed to get
the server functional as soon as possible, even if it is connected with less
bandwidth. there are no on-site spare cards available and the vendor does
not expect to have the parts for at least a week. Which of the following
immediately available N. I. C's. could be substituted instead? - ANSWER
33 megahertz 3.3 V PCI
Questions With Reviewed 100%
Correct Detailed Answers
Guaranteed Pass!!
1. Which of the following is the core software application that manages
computer virtualization? - ANSWER HYPERVISOR
2. Swap space or page file is reversed on the? - ANSWER HARD DRIVE
3. Which of the following is a requirement to a server to allow guests to be
installed in a hypervisor host? - ANSWER processors that support
virtualization
4. An administrator needs to deploy 1,000 servers in a short. Of time. Which
of the following deployment methods will expedite the O. S. installations? -
ANSWER use P. X. E. Boot to retrieve and image
5. Which of the following are required characteristics of database servers in
high transaction environments. select three - ANSWER high bandwidth,
higher R. P. M. Drives,
,load balancing
6. A network administrator is installing additional devices on the network.
Currently, the network segment is utilizing all allocated IP addresses. If
there are additional addresses available, which of the following would be
the best for the network administrator to perform to accommodate the
new network devices? - ANSWER increase the size of the D. H. C. P.
scope for the network segment in question
7. Which of the following allows virtual machines to share the N. I. C. of the
host? - ANSWER BRIDGING
8. And administrator is asked to change a configuration using a G. U. I. On a
Windows server, but does not have access to a K. V. M.. which of the
following is the best to make the change? - ANSWER R.D.P.
9. Several of the finance department computers are experiencing timeouts
while in their financial program. The program will not open or close,
however, the previous day the program was running without issues. Which
of the following is the most likely the cause of this problem? - ANSWER
ROGUE PROCESSES
10. A technician is assigned a task to configure a new server with six hard
drives. The senior administrator request the technician utilize the drive for
maximum fault tolerance. Which of the following RAID configurations
should the technician use? - ANSWER RAID 10
11. To read arrays are created from 8 disks. when is created using raid 6, the
other is created using raid 5 with a hot spare. Which of the following is the
, operational difference between these configurations? - ANSWER read
six has the ability to recover from two disks simultaneously failing.
12. A data center technician encounters a power receptacle labeled n. C. M. A.
L5 - 30. which of the following powers is the socket rated for? - ANSWER
115v 30 amp
13. A technician is experiencing overheating on a rack mounted server. After
powering off and removing the cover of the server, a large amount of dust
is noticed on one of the fans. After cleaning out the dust and powering the
server back on, the server is still overheating. Which of the following would
best explain this issue? - ANSWER some of the cooling fans are
defective
14. A technician notices a rack-mounted server is beeping without booting up.
The next step to diagnose this issue would be too? - ANSWER count the
beeps and reference the service manual
15. A server technician has been tasked with purchasing cables and connectors
for a new server room. The server room consists of one switch, two servers,
and one IP telephone. Which of the following types of cable and connectors
should the technician purchase? - ANSWER straight through Ethernet
cable and RJ-45 connectors
16. Which of the following is a basic difference between D. A. S. And N. A. S.? -
ANSWER D. A. S. is directly connected to a server. N. A. S. is connected
via IP networking
, 17. A technician is tasked with providing network-based high-availability to a
pair of identical web servers. Which of the following minimum server N. I.
C. configurations fulfill these requirements? - ANSWER one physical N.
I. C. per server. Each individual N. I. C. configured for Network loading
balancing
18. A system administrator is concerned with employees connecting
removable storage to the server to copy sensitive data. Which of the
following Solutions addresses this concern? - ANSWER disable physical
ports
19. Which of the following is a reason to have a remote code site readily
available in case of a disaster in the primary data center? - ANSWER it
provides a company with a backup location to install the necessary
equipment to restore critical services
20. A server in a small company functions as a print server. suddenly it stop
sending print jobs to the printers. a technician verifies that the printers are
working correctly. Additionally, The Print Spooler had been restarted it and
is running on the server, it is accessible from workstations, and it shows as
being ready to accept print jobs. which of the following has most likely
caused the print server to stop processing print jobs? - ANSWER the
servers hard drive is out of space
21. A mission-critical server has faulted with a dead 66 megahertz 3.3 V PCI - x
network interface card. the system administrator has been directed to get
the server functional as soon as possible, even if it is connected with less
bandwidth. there are no on-site spare cards available and the vendor does
not expect to have the parts for at least a week. Which of the following
immediately available N. I. C's. could be substituted instead? - ANSWER
33 megahertz 3.3 V PCI
