AUTOMOTIVE COLLISION ASE PRACTICE EXAM QUESTIONS
WITH CORRECT SOLUTIONS| ALREADY GRADED A| ACE YOUR
GRADES.
Technician A says that when replacing metal parts, an anti-corosion
material should be applied. Technician B says that some adhesive products
may contain anti-corrosion properties. Who is right?
A. A only
B. B only
C. Both A and B
D, Neither A nor B - Correct Answer-C. Both A and B
Technician A says that humidity can influence the rate of corrosion.
Technician B says that cold temperatures can accelerate the rate of
corrosion. Who is right?
A. A only
B. B only
C. Both A and B
D. Neither A nor B - Correct Answer-A. A only
Which of these is the best method to correct a filler weld with too little
penetration?
A. Increase the stick-out and increase the wire feed
, B. Increase the drive roll pressure and decrease the stick-out
C. Decrease the drive speed and increase the heat and wire feed
D. Increase the drive speed and decrease the stick-out - Correct Answer-A.
increase the stick-out and increase the wire feed
Which of these tools should be used to metal finish a damaged panel?
A. Pick hammer and a vixen file
B. A grater and in-line sander
C. An electric sander with 16-grit sandpaper
D. A stud pin welder - Correct Answer-B. A grater and in-line sander
Which of these characteristics would be the most noticeable difference
when metal finishing aluminum versus steel?
A. Work hardening
B. Ambient temperature
C. Location of damage
D. Alloy composition - Correct Answer-D. Alloy composition
When used to cut off a metal panel which of these tools would generate the
least amount of heat?
A. cut-off wheel
B. Plasma cutting torch
C. Air saw
D. Oxyacetylene cutting torch - Correct Answer-A. Air saw
WITH CORRECT SOLUTIONS| ALREADY GRADED A| ACE YOUR
GRADES.
Technician A says that when replacing metal parts, an anti-corosion
material should be applied. Technician B says that some adhesive products
may contain anti-corrosion properties. Who is right?
A. A only
B. B only
C. Both A and B
D, Neither A nor B - Correct Answer-C. Both A and B
Technician A says that humidity can influence the rate of corrosion.
Technician B says that cold temperatures can accelerate the rate of
corrosion. Who is right?
A. A only
B. B only
C. Both A and B
D. Neither A nor B - Correct Answer-A. A only
Which of these is the best method to correct a filler weld with too little
penetration?
A. Increase the stick-out and increase the wire feed
, B. Increase the drive roll pressure and decrease the stick-out
C. Decrease the drive speed and increase the heat and wire feed
D. Increase the drive speed and decrease the stick-out - Correct Answer-A.
increase the stick-out and increase the wire feed
Which of these tools should be used to metal finish a damaged panel?
A. Pick hammer and a vixen file
B. A grater and in-line sander
C. An electric sander with 16-grit sandpaper
D. A stud pin welder - Correct Answer-B. A grater and in-line sander
Which of these characteristics would be the most noticeable difference
when metal finishing aluminum versus steel?
A. Work hardening
B. Ambient temperature
C. Location of damage
D. Alloy composition - Correct Answer-D. Alloy composition
When used to cut off a metal panel which of these tools would generate the
least amount of heat?
A. cut-off wheel
B. Plasma cutting torch
C. Air saw
D. Oxyacetylene cutting torch - Correct Answer-A. Air saw
