ASPHALT PAVING LEVEL 1 ACTUAL UPDATED
EXAM WITH EXPERTLY AND CORRECTLY
ANSWERED QUESTIONS| ACE YOUR GRADES!!!
If a single load exceeds the established mix by -+ 25 degrees but is within
the master range, the technician will monitor the temperature of every load
until
A, The temperatures of five consecutive of 5 consecutive loads are all
within 20 degrees of the target temperature
-b,the average of any 5 consecutive loads are within 15 degrees of the
target
C, any single reading must be within 25 degrees of the target
D,the average of 5 consecutive loads is within 25 degrees of target
temperature. - Correct Answer-B and c
Given the target mix temperature of 290 degrees and the following truck
temperatures 280, 285, 295, 300, 275....
No action is required, just document the results
Reject the load exceeding the master range temperature target
Check the next 5 loads to see if in tolerance and notify the plant - Correct
Answer-No action is required
What temperature is tack coat material corrected to for tack spread rate
calculations?
, 60
77
175
320 - Correct Answer-60
Tack coats are required
Betweeen successful lifts of asphalt base material
On all structural course asphalt layers to constructing the next course
None of the above
Both A and B - Correct Answer-Both A and B
The application rate for PG 52-28 tack is the same as for emulsion T/F -
Correct Answer-False
A tack truck distributor tank reading of 20/15 translates to - Correct Answer-
20 inches 15/16s inches
EXAM WITH EXPERTLY AND CORRECTLY
ANSWERED QUESTIONS| ACE YOUR GRADES!!!
If a single load exceeds the established mix by -+ 25 degrees but is within
the master range, the technician will monitor the temperature of every load
until
A, The temperatures of five consecutive of 5 consecutive loads are all
within 20 degrees of the target temperature
-b,the average of any 5 consecutive loads are within 15 degrees of the
target
C, any single reading must be within 25 degrees of the target
D,the average of 5 consecutive loads is within 25 degrees of target
temperature. - Correct Answer-B and c
Given the target mix temperature of 290 degrees and the following truck
temperatures 280, 285, 295, 300, 275....
No action is required, just document the results
Reject the load exceeding the master range temperature target
Check the next 5 loads to see if in tolerance and notify the plant - Correct
Answer-No action is required
What temperature is tack coat material corrected to for tack spread rate
calculations?
, 60
77
175
320 - Correct Answer-60
Tack coats are required
Betweeen successful lifts of asphalt base material
On all structural course asphalt layers to constructing the next course
None of the above
Both A and B - Correct Answer-Both A and B
The application rate for PG 52-28 tack is the same as for emulsion T/F -
Correct Answer-False
A tack truck distributor tank reading of 20/15 translates to - Correct Answer-
20 inches 15/16s inches
