ROPE RESCUE OPS IFSI NEWEST 2025 ACTUAL EXAM
COMPLETE 100 +QUESTIONS AND CORRECT DETAILED
ANSWERS (VERIFIED ANSWERS) |ALREADY GRADED
A+||BRAND NEW VERSION!!
.1 in tubular webbing has a tensile strength of approx - Answer-4000lbs
.8mm & 9mm accessory cord is - Answer-Covered in the cordage institute rope construction standards
.A 15:1 ratio for rope strength use to be a NFPA standard but a more realistic ratio is suggested to be -
Answer-10:1
.A bottom belay will - Answer-will not arrest a fall if the main line fails.
.A class one harness is designed to stop rescuer when he: - Answer-Reaches the edge
.A double overhand knot is also referred to as a - Answer-barrel knot, back-up knot, safety knot
.A helmet used for repor rescue should be an approved light weight helmet with a: - Answer-3 point strap
position under the chin
.A knot used to isolate a bad spot in the line in an emergency is a: - Answer-lineman's loop
.A knot used to join webbing together is referred to as a/an - Answer-Water knot, ring-bend knot, Overhand
bend knot
.A knot with a small internal radius bends, as those found in square knots or over hand knots will .... when
, tied in 1/2 inch kernmantle rope - Answer-be weaker
.A munter can be used as a means of lowering a load 300 lbs or less in an emergency and also for - Answer-
rappelling
.A munter system is designed for loads less than - Answer-300 lb
.A type of knot construction used to join two ends of the webbing together and at the same time create a
loop in the end of the webbing is called a - Answer-frost knot
.Accessory cord used in the construction of a load releasing hitch can be - Answer-either 8mm or 9mm
.All equip. that falls 3 ft onto a hard surface shall be checked for: - Answer-Burs, sharp edges, dirt,
contaminates, lose parts and deformaties
.All harness construction and testing standards are covered in NFPA: - Answer-1983
.All riggin shall have how many checks prior to Loading? - Answer-3
.Besides a minimum diameter of 11mm G rated rope, NFPA requirements also call for - Answer-Rope
diameter, elongation, minimum temperature
.Besides holding or capturing a load line, prusiks are used for: - Answer-Self-rescue
.Braided ropes are/have: - Answer-easy to pick bundles in soft braids
.Carabiners used in fall protection equipment designed for tower climbing shall per OSHA be designed with: -
Answer-A self closing self locking design
COMPLETE 100 +QUESTIONS AND CORRECT DETAILED
ANSWERS (VERIFIED ANSWERS) |ALREADY GRADED
A+||BRAND NEW VERSION!!
.1 in tubular webbing has a tensile strength of approx - Answer-4000lbs
.8mm & 9mm accessory cord is - Answer-Covered in the cordage institute rope construction standards
.A 15:1 ratio for rope strength use to be a NFPA standard but a more realistic ratio is suggested to be -
Answer-10:1
.A bottom belay will - Answer-will not arrest a fall if the main line fails.
.A class one harness is designed to stop rescuer when he: - Answer-Reaches the edge
.A double overhand knot is also referred to as a - Answer-barrel knot, back-up knot, safety knot
.A helmet used for repor rescue should be an approved light weight helmet with a: - Answer-3 point strap
position under the chin
.A knot used to isolate a bad spot in the line in an emergency is a: - Answer-lineman's loop
.A knot used to join webbing together is referred to as a/an - Answer-Water knot, ring-bend knot, Overhand
bend knot
.A knot with a small internal radius bends, as those found in square knots or over hand knots will .... when
, tied in 1/2 inch kernmantle rope - Answer-be weaker
.A munter can be used as a means of lowering a load 300 lbs or less in an emergency and also for - Answer-
rappelling
.A munter system is designed for loads less than - Answer-300 lb
.A type of knot construction used to join two ends of the webbing together and at the same time create a
loop in the end of the webbing is called a - Answer-frost knot
.Accessory cord used in the construction of a load releasing hitch can be - Answer-either 8mm or 9mm
.All equip. that falls 3 ft onto a hard surface shall be checked for: - Answer-Burs, sharp edges, dirt,
contaminates, lose parts and deformaties
.All harness construction and testing standards are covered in NFPA: - Answer-1983
.All riggin shall have how many checks prior to Loading? - Answer-3
.Besides a minimum diameter of 11mm G rated rope, NFPA requirements also call for - Answer-Rope
diameter, elongation, minimum temperature
.Besides holding or capturing a load line, prusiks are used for: - Answer-Self-rescue
.Braided ropes are/have: - Answer-easy to pick bundles in soft braids
.Carabiners used in fall protection equipment designed for tower climbing shall per OSHA be designed with: -
Answer-A self closing self locking design
