CWB EXAM STUDY GUIDE / 70 +
QUESTIONS AND CORRECT
ANSWERS 2025/2026
LATEST UPDATE ALREADY
GRADED A+.
1/2
, 1. The welding inspector's role in welding begins ANSWER ANSWER before welding starts
2. Prior to welding, the welding inspector should check that the ANSWER ANSWER
approved welding procedures are available and the welders are qualified
3. Which is not the function of the welding inspector? ANSWER Developing a repair
procedure
4. If during a manufacturing inspection, cracking is found on the outside of a pressure vessel
weld, the inspector shall ANSWER ANSWER record the details of the crack, immediately draw
it to the attention of the welding supervisor or the welder and check that it is repaired in accordance
with an authorized repair procedure
5. The Material Test Report (MTR) is a (an) ANSWER important document that provides the owner
(and the fabricator) with the ability to identify properly qualified materials.
6. The material test report (MRT) ANSWER provides mechanical test results that confirm that
the product covered meets the specification.
7. Reports produced by the welding inspector should be; ANSWER neat and accurate
8. When reviewing a fabricator's ITP on behalf of the client, the welding inspec- tor should
ANSWER ANSWER indicate any hold points so that he may witness specific activities
9. Which information would be expected on the fabricator's ITP? ANSWER The point in the
project at which welding starts
10. Following completion of the welding operation, the welding inspector ANSWER ANSWER -
checks that all the required welds have been made
11. Steels meeting any grade of CAN/CSA-40.21 must also meet the require- ments of
ANSWER ANSWER CAN / CSA-40.20
12. Which information might be found on an MTR (mill test report or certifi- cate) ANSWER
2/2
QUESTIONS AND CORRECT
ANSWERS 2025/2026
LATEST UPDATE ALREADY
GRADED A+.
1/2
, 1. The welding inspector's role in welding begins ANSWER ANSWER before welding starts
2. Prior to welding, the welding inspector should check that the ANSWER ANSWER
approved welding procedures are available and the welders are qualified
3. Which is not the function of the welding inspector? ANSWER Developing a repair
procedure
4. If during a manufacturing inspection, cracking is found on the outside of a pressure vessel
weld, the inspector shall ANSWER ANSWER record the details of the crack, immediately draw
it to the attention of the welding supervisor or the welder and check that it is repaired in accordance
with an authorized repair procedure
5. The Material Test Report (MTR) is a (an) ANSWER important document that provides the owner
(and the fabricator) with the ability to identify properly qualified materials.
6. The material test report (MRT) ANSWER provides mechanical test results that confirm that
the product covered meets the specification.
7. Reports produced by the welding inspector should be; ANSWER neat and accurate
8. When reviewing a fabricator's ITP on behalf of the client, the welding inspec- tor should
ANSWER ANSWER indicate any hold points so that he may witness specific activities
9. Which information would be expected on the fabricator's ITP? ANSWER The point in the
project at which welding starts
10. Following completion of the welding operation, the welding inspector ANSWER ANSWER -
checks that all the required welds have been made
11. Steels meeting any grade of CAN/CSA-40.21 must also meet the require- ments of
ANSWER ANSWER CAN / CSA-40.20
12. Which information might be found on an MTR (mill test report or certifi- cate) ANSWER
2/2
