• Wrong document? Swap it for free
  • Written by students who passed
  • Immediately available after payment
  • Read online or as PDF
Sell
Where do you study
Your language
Document preview thumbnail
Preview 2 out of 5 pages
Exam (elaborations)

BECC Mod 4 Exam Questions and Answers Graded A+ (Already Passed)

Document preview thumbnail
Preview 2 out of 5 pages

BECC Mod 4 Exam Questions and Answers Graded A+ (Already Passed) The Fireman System originates below the waterline with the __________. - Answers Sea Chest Which valve is the last valve you open before putting the pump on line and the first valve you will shut when securing the pump? - Answers Fire Pump Discharge Valve What valves are used to isolate system components? - Answers Cutout, Discharge, and Cross Connect Valves Gate, Ball, Globe (Pump Discharge), or High Performance butterfly valves are considered ________________. - Answers Cutout Valves For which monitoring method must the assigned watchstander notify DCC that the fire pump is aligned for operation? - Answers Local Secondary, or alternate fireman monitoring is conducted from the Damage Control Deck, or under emergency conditions at the _________. - Answers Pump Which methods are used to control fire pump or firemain valve operations? - Answers Remote, Local, and Automatic Relief valves protect the fireman system from over-pressurization by relieving pressure at approximately _____ PSIG above the firemain design pressure. - Answers 50 Where is a coupling guard installed on the fire pump? - Answers Over the rotating shaft Which pipe runs fore-to-aft of the ship and carries the firemain water? - Answers Main The _________ firemain system uses a main that extends forward and aft on the damage control deck. - Answers Single Which firemain system consists of two single fore-and-aft, cross connected mains? - Answers Horizontal loop In the vertical offset loop firemain system, the two mains are separated __________________. - Answers Vertically & Horizontally The composite firemain system consists of ___________________ installed on the damage control deck and separated athwartships. - Answers two mains When a loss of firemain occurs, audible and visual alarms are received where? - Answers At DCC After rigging a jumper hose, you can restore the firemain system by... - Answers Consulting your ship's EOSS for starting a fire pump; Notify the watchstander to investigate and report the cause of the loss of firemain; Inform the EDO/EOOW of the investigation results and take appropriate actions. What are possible causes for a loss of firemain pressure? - Answers -Clogged sea water strainer -Insufficient fire pump for the demand -Normal wear and tear - Loss of power -Clogged pump suction valve What are the valid affects on the firemain system when you are addressing a failed fire pump? - Answers -Chilled water and electronic cooling systems will not function at 100 percent or will fail to operate correctly. -The system may not be able to deliver adequate firemain pressure for other fire fighting equipment. -The compartment sprinkler system will lack adequate pressure for suppression. You have finished rigging the jumper hose, to whom do you report that information? - Answers Damage Control Central The main drainage system is used for dewatering _________ machinery spaces. - Answers Main The secondary drainage system is used for dewatering spaces _____________ of the machinery compartments. - Answers Forward & aft

Content preview

BECC Mod 4 Exam Questions and Answers Graded A+ (Already Passed)



The Fireman System originates below the waterline with the __________. - Answers Sea Chest

Which valve is the last valve you open before putting the pump on line and the first valve you will shut
when securing the pump? - Answers Fire Pump Discharge Valve

What valves are used to isolate system components? - Answers Cutout, Discharge, and Cross Connect
Valves

Gate, Ball, Globe (Pump Discharge), or High Performance butterfly valves are considered
________________. - Answers Cutout Valves

For which monitoring method must the assigned watchstander notify DCC that the fire pump is aligned
for operation? - Answers Local

Secondary, or alternate fireman monitoring is conducted from the Damage Control Deck, or under
emergency conditions at the _________. - Answers Pump

Which methods are used to control fire pump or firemain valve operations? - Answers Remote, Local,
and Automatic

Relief valves protect the fireman system from over-pressurization by relieving pressure at approximately
_____ PSIG above the firemain design pressure. - Answers 50

Where is a coupling guard installed on the fire pump? - Answers Over the rotating shaft

Which pipe runs fore-to-aft of the ship and carries the firemain water? - Answers Main

The _________ firemain system uses a main that extends forward and aft on the damage control deck. -
Answers Single

Which firemain system consists of two single fore-and-aft, cross connected mains? - Answers Horizontal
loop

In the vertical offset loop firemain system, the two mains are separated __________________. -
Answers Vertically & Horizontally

The composite firemain system consists of ___________________ installed on the damage control deck
and separated athwartships. - Answers two mains

When a loss of firemain occurs, audible and visual alarms are received where? - Answers At DCC

After rigging a jumper hose, you can restore the firemain system by... - Answers Consulting your ship's
EOSS for starting a fire pump; Notify the watchstander to investigate and report the cause of the loss of
firemain; Inform the EDO/EOOW of the investigation results and take appropriate actions.

, What are possible causes for a loss of firemain pressure? - Answers -Clogged sea water strainer

-Insufficient fire pump for the demand

-Normal wear and tear

- Loss of power

-Clogged pump suction valve

What are the valid affects on the firemain system when you are addressing a failed fire pump? - Answers
-Chilled water and electronic cooling systems will not function at 100 percent or will fail to operate
correctly.

-The system may not be able to deliver adequate firemain pressure for other fire fighting equipment.

-The compartment sprinkler system will lack adequate pressure for suppression.

You have finished rigging the jumper hose, to whom do you report that information? - Answers Damage
Control Central

The main drainage system is used for dewatering _________ machinery spaces. - Answers Main

The secondary drainage system is used for dewatering spaces _____________ of the machinery
compartments. - Answers Forward & aft

Special drainage systems are used for _______________ space. - Answers Sanitation & ammunition

What are the different types of pumps that are used to create power flow? - Answers Electrical, steam,
internal combustion, and water driven

Which components are used in drainage system? - Answers Valves, piping, and pumps

The ______ must give permission for eductor operations while inport. - Answers EDO

What step-by-step procedure must be consulted to align an eductor for proper operation? - Answers
EOSS

_________________ prohibits the discharge of oil into inland or coastal waters. - Answers Federal law

What person must give permission for eductor operations while underway? - Answers EOOW

Once the space has been dewatered, and the eductor is secured, ensure thr space has adequate
__________ before personnel can enter. - Answers Oxygen

Which of the following statements apply to the secondary drainage system? - Answers It is independent
of the main drainage system

What category of drainage systems are gravity drains? - Answers Special drainage system

Document information

Uploaded on
December 30, 2024
Number of pages
5
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers
$8.89

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
TutorJosh
3.5
(76)
Sold
497
Followers
16
Items
32941
Last sold
1 day ago




Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions