Jatc test 2 Job info level 1 with complete
solutions passed
___ or socket wrench are safest to remove frozen fasteners - correct answer ✔✔Box
Excessive ___ causes wrenches to weaken - correct answer ✔✔heating
Never____ on a screwdriver - correct answer ✔✔Hammer
Use a ____ wrench to avoid marring a pipe - correct answer ✔✔Strap
slip joint pliers are sometimes referred to as ____ and groove pliers. - correct answer ✔✔tongue
The 3 parts of the screw driver consist of the handle , blade and____? - correct answer ✔✔shank
linemen's side cutting pliers have two main styles. One being square nose and the other? - correct
answer ✔✔New England nose
Safe practices in the job site include? - correct answer ✔✔1)Removing jewelry and rings.
2)Removing fasteners / staples from packing boxes before removing contents
3)Stack waste materials so weight is evenly distributed
4)Cleaning up after each small job is finished
Trash accumulation on the jobsite: - correct answer ✔✔1) conceals dangers underneath
2) Creates a fire hazard
3)makes falls likely '
4)Does not indicate a productive work day.
, A neat jobsite can be an asset for you, the contractor , the customer and lead to _____? - correct answer
✔✔Future work
Causes of accidents on a job are unsafe conditions and ____? - correct answer ✔✔Unsafe acts
Apprentices are in charge of clean-up because they are cheap and lack ___? - correct answer
✔✔experience
___are responsible for job safety. - correct answer ✔✔You
Ladders not in use should be laid down or ___. - correct answer ✔✔Lashed
Always keep both hands ___ when ascending and descending ladders. - correct answer ✔✔Free
Leaning a step ladder against the wall to use is ____. - correct answer ✔✔Unsafe
Max length for a fully extended ladder is __? - correct answer ✔✔55ft
Extension ladders should have at least ___ over lap between section when extended. - correct answer
✔✔3ft
Single ladders longer than ___ feet should not be used. - correct answer ✔✔30ft
Ladders should extend36 inches or ___ over a roof edge , scaffold, or beam. - correct answer ✔✔3 ft
Stepladders of over ____ should not be used - correct answer ✔✔20Ft
Do not stand on the top ___ of a ladder - correct answer ✔✔two steps
____ is an unsafe act while working on ladders - correct answer ✔✔Over reaching
solutions passed
___ or socket wrench are safest to remove frozen fasteners - correct answer ✔✔Box
Excessive ___ causes wrenches to weaken - correct answer ✔✔heating
Never____ on a screwdriver - correct answer ✔✔Hammer
Use a ____ wrench to avoid marring a pipe - correct answer ✔✔Strap
slip joint pliers are sometimes referred to as ____ and groove pliers. - correct answer ✔✔tongue
The 3 parts of the screw driver consist of the handle , blade and____? - correct answer ✔✔shank
linemen's side cutting pliers have two main styles. One being square nose and the other? - correct
answer ✔✔New England nose
Safe practices in the job site include? - correct answer ✔✔1)Removing jewelry and rings.
2)Removing fasteners / staples from packing boxes before removing contents
3)Stack waste materials so weight is evenly distributed
4)Cleaning up after each small job is finished
Trash accumulation on the jobsite: - correct answer ✔✔1) conceals dangers underneath
2) Creates a fire hazard
3)makes falls likely '
4)Does not indicate a productive work day.
, A neat jobsite can be an asset for you, the contractor , the customer and lead to _____? - correct answer
✔✔Future work
Causes of accidents on a job are unsafe conditions and ____? - correct answer ✔✔Unsafe acts
Apprentices are in charge of clean-up because they are cheap and lack ___? - correct answer
✔✔experience
___are responsible for job safety. - correct answer ✔✔You
Ladders not in use should be laid down or ___. - correct answer ✔✔Lashed
Always keep both hands ___ when ascending and descending ladders. - correct answer ✔✔Free
Leaning a step ladder against the wall to use is ____. - correct answer ✔✔Unsafe
Max length for a fully extended ladder is __? - correct answer ✔✔55ft
Extension ladders should have at least ___ over lap between section when extended. - correct answer
✔✔3ft
Single ladders longer than ___ feet should not be used. - correct answer ✔✔30ft
Ladders should extend36 inches or ___ over a roof edge , scaffold, or beam. - correct answer ✔✔3 ft
Stepladders of over ____ should not be used - correct answer ✔✔20Ft
Do not stand on the top ___ of a ladder - correct answer ✔✔two steps
____ is an unsafe act while working on ladders - correct answer ✔✔Over reaching
