Texas state inspector test part 2
one of the required procedures in the inspection of the steering is: - answer Turning off
the Steering wheel from full left to full right
conventional brakes or non-power brakes must have a minimum pedal reserve of: -
answer2 inch
any tire with wear bar indicators would be rejected for the following - answer tread wear
indicators are in contact with the road in one major groove in three locations around the
tire
LED tail lamps may have no more than __ of the diodes malfunctioning to pass
inspection - answer50%
when performing the road test on the service brakes, a truck weighing over 10,000
pounds gross weight ( this would include larger trucks but not truck- Trailer
combinations) should be driven at 20 mph and stop within: - answer40 feet
The Vehicle owner/ operator should be present when inspector is checking CNG tank
located in the trunk of the car - answer True
Glass Coating or sun screening materials on windshields may not extend down past the
AS-1 lone or more than __ inches, whichever is closer to the top of the windshield -
answer five inches
Brakes would be rejected if: - answerThere is an obvious metal to metal contact when
brakes are applied.
when issuing a vehicle inspection report to a vehicle, VIN will be taken from the: -
answerVehicle
proof of Financial responsiblity is not required on motor Vehicles prior to year model
1988 - answerFalse
when is a vehicle required to be inspected for seatbelts - answeranchorages were part
of the manufacturer's original equipment
the turn signal selector switch must lock in the proper turn position when applied on -
answerall vehicles
a truck or trailer is required to have clearance lamp sand side marker lamps and side
marker lamps if the total width of the vehicles is: - answer80 inches or more
one of the required procedures in the inspection of the steering is: - answer Turning off
the Steering wheel from full left to full right
conventional brakes or non-power brakes must have a minimum pedal reserve of: -
answer2 inch
any tire with wear bar indicators would be rejected for the following - answer tread wear
indicators are in contact with the road in one major groove in three locations around the
tire
LED tail lamps may have no more than __ of the diodes malfunctioning to pass
inspection - answer50%
when performing the road test on the service brakes, a truck weighing over 10,000
pounds gross weight ( this would include larger trucks but not truck- Trailer
combinations) should be driven at 20 mph and stop within: - answer40 feet
The Vehicle owner/ operator should be present when inspector is checking CNG tank
located in the trunk of the car - answer True
Glass Coating or sun screening materials on windshields may not extend down past the
AS-1 lone or more than __ inches, whichever is closer to the top of the windshield -
answer five inches
Brakes would be rejected if: - answerThere is an obvious metal to metal contact when
brakes are applied.
when issuing a vehicle inspection report to a vehicle, VIN will be taken from the: -
answerVehicle
proof of Financial responsiblity is not required on motor Vehicles prior to year model
1988 - answerFalse
when is a vehicle required to be inspected for seatbelts - answeranchorages were part
of the manufacturer's original equipment
the turn signal selector switch must lock in the proper turn position when applied on -
answerall vehicles
a truck or trailer is required to have clearance lamp sand side marker lamps and side
marker lamps if the total width of the vehicles is: - answer80 inches or more
