©BRAINBARTER EXAM SOLUTIONS 2024/2025
ALL RIGHTS RESERVED.
CDC 2w051 set B Exam Questions And
Correct Answers
Before using an electrical drill, what is the first thing you should do? - answer✔Make sure the diameter
of the hole to be drilled is within the capacity of the drill.
The purpose of cutting lubricant in most drilling operations is to increase the - answer✔drilling speed
and the drill bit life
which minimum articles of safety gear must be worn when using a bench grinder - answer✔Eye and
Face protection
An Electrical saw blade must be operating at what speed before it contacts the material being cut? -
answer✔Full
How many pounds per square inch (psi) of clean, dry air is required at the tool end of the air hose to
ensure the tool is operating safely and efficiently? - answer✔90
What condition would prevent an operator rom applying power to a hoist or other powered lifting
device? - answer✔An AF Form 979 is attached to the unit.
What should be worn anytime there is a potential for injury from overhead objects during a lifting
operation. - answer✔Protective helmets
What is the most common type of lifting sling used in the munitions career field? - answer✔Wire rope
The following are all good safety practices to follow when using a lifting sling except -
answer✔inspecting the sling by passing your bare hand over the body of the sling
The annunciators displayed on the Fluke 8025 series millimeter are used to distinguish among. -
answer✔Ohms, Kilohms, and megohms
What are the two operational modes of the Fluke 8025-series multimeter? - answer✔Range and hold
The sterring system on the MHU-141/M trailer has a turning radius of how many inches? - answer✔200
When the MHU-141 trailer is loaded or towed with the hinged deck open, what must be done? -
answer✔The deck-panel supports must be properly positioned and locked in place with quick-release
pins.
1|Page
, ©BRAINBARTER EXAM SOLUTIONS 2024/2025
ALL RIGHTS RESERVED.
What is the maximum load capacity of the MHU-110/M trailer? - answer✔15,000 pounds
The parking brake on the MHU-110/M is applied by - answer✔pulling either one of two hand levers
located on each side of the front of trailer.
How many openings (hinged door panels) are on the deck of the MHU-226 trailer? - answer✔three
What type of steering aids the MHU-226 in a tighter steering radius? - answer✔Four-wheel double
Ackerman
What kind of movement supports on-base activities to or from the flightline? - answer✔Operational
After 463L pallets are positioned trailer, what can you use to secure the pallets to the trailer? -
answer✔MB-1 chain assemblies and/or tie-down straps
What munitions item is not loaded into transport modules by munitions personnel? - answer✔20mm
What transport module used for decoy munitions has a maximum capacity of 30 magazines? -
answer✔ALE-50
How often should the positive locking device on the doors of munitions transport modules be checked? -
answer✔After loading, unloading, and periodically between stops
The purpose of the transport beam beneath the lift arm assemblies on the MJ-1 series lift truck is to -
answer✔provide added support and to relieve hydraulic pressure from the lift arms when carrying loads
for long distances
What is the lifting capacity of the MJ-1 series lift truck? - answer✔3,000 pounds
What is the lifting capacity of the MHU-83-series lift truck? - answer✔7,000 pounds
when using the MHU-83 series lift with fork adapters, you immediately - answer✔reduce the lifting
capability by 1000 pounds
what happens when you release the accelerator pedal on vehicle driven with a hydrostatic
transmission? - answer✔the unit coast to a stop very quickly
what is the primary drawback to using the hydraulic hand pump to build hydraulic pressure on the MHU-
83 series lift truck? - answer✔extremely slow way to build hydraulic pressure
How is the yaw positioning from the cradle or boom controls of an MJ-1 lift truck adjusted? -
answer✔Manually
what category or categories are Air Force air compressors classified? - answer✔High or low pressure
The primary difference between a bobtail and a pickup truck is the - answer✔bobtail's back end is
shortened by about one half
2|Page
ALL RIGHTS RESERVED.
CDC 2w051 set B Exam Questions And
Correct Answers
Before using an electrical drill, what is the first thing you should do? - answer✔Make sure the diameter
of the hole to be drilled is within the capacity of the drill.
The purpose of cutting lubricant in most drilling operations is to increase the - answer✔drilling speed
and the drill bit life
which minimum articles of safety gear must be worn when using a bench grinder - answer✔Eye and
Face protection
An Electrical saw blade must be operating at what speed before it contacts the material being cut? -
answer✔Full
How many pounds per square inch (psi) of clean, dry air is required at the tool end of the air hose to
ensure the tool is operating safely and efficiently? - answer✔90
What condition would prevent an operator rom applying power to a hoist or other powered lifting
device? - answer✔An AF Form 979 is attached to the unit.
What should be worn anytime there is a potential for injury from overhead objects during a lifting
operation. - answer✔Protective helmets
What is the most common type of lifting sling used in the munitions career field? - answer✔Wire rope
The following are all good safety practices to follow when using a lifting sling except -
answer✔inspecting the sling by passing your bare hand over the body of the sling
The annunciators displayed on the Fluke 8025 series millimeter are used to distinguish among. -
answer✔Ohms, Kilohms, and megohms
What are the two operational modes of the Fluke 8025-series multimeter? - answer✔Range and hold
The sterring system on the MHU-141/M trailer has a turning radius of how many inches? - answer✔200
When the MHU-141 trailer is loaded or towed with the hinged deck open, what must be done? -
answer✔The deck-panel supports must be properly positioned and locked in place with quick-release
pins.
1|Page
, ©BRAINBARTER EXAM SOLUTIONS 2024/2025
ALL RIGHTS RESERVED.
What is the maximum load capacity of the MHU-110/M trailer? - answer✔15,000 pounds
The parking brake on the MHU-110/M is applied by - answer✔pulling either one of two hand levers
located on each side of the front of trailer.
How many openings (hinged door panels) are on the deck of the MHU-226 trailer? - answer✔three
What type of steering aids the MHU-226 in a tighter steering radius? - answer✔Four-wheel double
Ackerman
What kind of movement supports on-base activities to or from the flightline? - answer✔Operational
After 463L pallets are positioned trailer, what can you use to secure the pallets to the trailer? -
answer✔MB-1 chain assemblies and/or tie-down straps
What munitions item is not loaded into transport modules by munitions personnel? - answer✔20mm
What transport module used for decoy munitions has a maximum capacity of 30 magazines? -
answer✔ALE-50
How often should the positive locking device on the doors of munitions transport modules be checked? -
answer✔After loading, unloading, and periodically between stops
The purpose of the transport beam beneath the lift arm assemblies on the MJ-1 series lift truck is to -
answer✔provide added support and to relieve hydraulic pressure from the lift arms when carrying loads
for long distances
What is the lifting capacity of the MJ-1 series lift truck? - answer✔3,000 pounds
What is the lifting capacity of the MHU-83-series lift truck? - answer✔7,000 pounds
when using the MHU-83 series lift with fork adapters, you immediately - answer✔reduce the lifting
capability by 1000 pounds
what happens when you release the accelerator pedal on vehicle driven with a hydrostatic
transmission? - answer✔the unit coast to a stop very quickly
what is the primary drawback to using the hydraulic hand pump to build hydraulic pressure on the MHU-
83 series lift truck? - answer✔extremely slow way to build hydraulic pressure
How is the yaw positioning from the cradle or boom controls of an MJ-1 lift truck adjusted? -
answer✔Manually
what category or categories are Air Force air compressors classified? - answer✔High or low pressure
The primary difference between a bobtail and a pickup truck is the - answer✔bobtail's back end is
shortened by about one half
2|Page
