Category 3 Non-Cab Operated Crane Safety Exam
Questions and Answers 100% Pass
A floating crane with a capacity of 200,000lbs. is a ________________ crane. - ✔✔Category 1
What is the category of a jib crane with a capacity of less than 20,000 pounds? - ✔✔Category 3
An OET, Bridge crane with a capacity of 80,000lbs. is a ________________ crane. - ✔✔Category 2
A commercial truck mounted crane with a capacity of 14,000 lbs. is a __________ crane. - ✔✔category 4
What types of power does a Category 1 or 4 crane generally use and what is its source? - ✔✔Electric or
hydraulic power supplied by a diesel engine
Load - ________ parts are those that restrain position or control the movement of the load. - ✔✔controling
A hook is what type of component? - ✔✔Load-Bearing Part
Hydraulic foot brakes are what type or group of components? - ✔✔Load-Controlling Parts
Load - _____________ parts are those that support the load. - ✔✔bearing
How is electrical current conveyed from the revolving portion of the crane to the lower crane structure? -
✔✔Through the collector ring system
Safety devices that provide protection for personnel and equipment are considered _____________ safety
devices. - ✔✔general
Safety devices that affect the safe load lifting and handling capabilities of equipment are considered
__________________ safety devices. - ✔✔operational
Which of the following does not affect the safe operation of the crane? - ✔✔General Safety Devices
Page 1/11
©EmilyCharlene 2024. All Rights Reserved.
, A travel alarm is what type or group of components? - ✔✔
A travel alarm is what type or group of components? - ✔✔General Safety Device
During the walk around check you notice a loose bolt on the crane. You should: - ✔✔Notify your
supervisor of the deficiency.
The crane Pre-use Check consists of: - ✔✔A walk around visual check
Performing a "No load" operational
It is the operator's responsibility to report a deficiency to the Crane Department. - ✔✔false
Deficiencies are required to be reported by the end of the shift. - ✔✔false
If the upper limit switch is working correctly, there is no need to check the lower limit switch. - ✔✔fasle
Part of the no load operational check is to ensure the proper _________ of all controls. - ✔✔function
What is the most important reason to do a pre-use check? - ✔✔To make sure the crane is safe to use.
Documented checks are required for which of the following Category 3 cranes? - ✔✔gantry
wall
bridge
Place the steps listed in the correct order to check the Upper Limit Switch on a hoist. - ✔✔Raise hoist two
feet below switch & stop
2.Slowly raise hook block into switch
3.Ensure hoist stops with button depressed
There must always be a minimum of _________ full wraps of wire rope on grooved drums. - ✔✔2
Part of the walk around check is to look for ___________. - ✔✔deficiencies
Page 2/11
©EmilyCharlene 2024. All Rights Reserved.
Questions and Answers 100% Pass
A floating crane with a capacity of 200,000lbs. is a ________________ crane. - ✔✔Category 1
What is the category of a jib crane with a capacity of less than 20,000 pounds? - ✔✔Category 3
An OET, Bridge crane with a capacity of 80,000lbs. is a ________________ crane. - ✔✔Category 2
A commercial truck mounted crane with a capacity of 14,000 lbs. is a __________ crane. - ✔✔category 4
What types of power does a Category 1 or 4 crane generally use and what is its source? - ✔✔Electric or
hydraulic power supplied by a diesel engine
Load - ________ parts are those that restrain position or control the movement of the load. - ✔✔controling
A hook is what type of component? - ✔✔Load-Bearing Part
Hydraulic foot brakes are what type or group of components? - ✔✔Load-Controlling Parts
Load - _____________ parts are those that support the load. - ✔✔bearing
How is electrical current conveyed from the revolving portion of the crane to the lower crane structure? -
✔✔Through the collector ring system
Safety devices that provide protection for personnel and equipment are considered _____________ safety
devices. - ✔✔general
Safety devices that affect the safe load lifting and handling capabilities of equipment are considered
__________________ safety devices. - ✔✔operational
Which of the following does not affect the safe operation of the crane? - ✔✔General Safety Devices
Page 1/11
©EmilyCharlene 2024. All Rights Reserved.
, A travel alarm is what type or group of components? - ✔✔
A travel alarm is what type or group of components? - ✔✔General Safety Device
During the walk around check you notice a loose bolt on the crane. You should: - ✔✔Notify your
supervisor of the deficiency.
The crane Pre-use Check consists of: - ✔✔A walk around visual check
Performing a "No load" operational
It is the operator's responsibility to report a deficiency to the Crane Department. - ✔✔false
Deficiencies are required to be reported by the end of the shift. - ✔✔false
If the upper limit switch is working correctly, there is no need to check the lower limit switch. - ✔✔fasle
Part of the no load operational check is to ensure the proper _________ of all controls. - ✔✔function
What is the most important reason to do a pre-use check? - ✔✔To make sure the crane is safe to use.
Documented checks are required for which of the following Category 3 cranes? - ✔✔gantry
wall
bridge
Place the steps listed in the correct order to check the Upper Limit Switch on a hoist. - ✔✔Raise hoist two
feet below switch & stop
2.Slowly raise hook block into switch
3.Ensure hoist stops with button depressed
There must always be a minimum of _________ full wraps of wire rope on grooved drums. - ✔✔2
Part of the walk around check is to look for ___________. - ✔✔deficiencies
Page 2/11
©EmilyCharlene 2024. All Rights Reserved.
