1|Pag e
SOS MECHANIC CERTIFICATION- SUSPENSION &
STEERING TEST EXAM|| ACTUAL EXAM ALL
QUESTIONS AND 100% CORRECT ANSWERS
ALREADY GRADED A+|| LATEST AND COMPLETE
UPDATE 2024-2025 WITH VERIFIES SOLUTIONS||
ASSURED PASS!!!
Bleeding a power steering unit is generally done by
turning the steering wheel left and right repeatedly
After rounding a turn, the front wheels do not return to the straight ahead position
in a normal way. What adjustment is most likely to be out of specifications?
Caster
"Toe" adjustment on front wheel drive vehicles is made by:
changing he length of the steering linkage
When performing a front-end alignment what should you do before you adjust the
toe setting?
adjust the caster & camber
Front-wheel toe-in adjustment on rear-wheel drive vehicles is made by:
, 2|Pag e
changing the length of the steering linkage
A mechanic is going to adjust the curb height on a car with torsion bars. To do this
the car should be checked:
on a level surface with the car at curb weight
A proper way to check ball joints for wear is by:
visual observation of the wear indicator & unloading the ball joint and using a pry
bar and a dial indicator
which of the following adjustments can be made on all vehicles with MacPherson
strut suspensions?
Toe settings
You are checking the war on ball joints with a dial indicator at the wheel rim. What
must you do to get accurate readings?
check the wheel bearing adjustment and correct if needed
A mechanic jacks up a car, stands facing it, places a hand on the front of each tire.
The mechanic pushes out and then pulls in on both tires. Too much movement
would most likely mean that:
the tie rod ends are worn
SOS MECHANIC CERTIFICATION- SUSPENSION &
STEERING TEST EXAM|| ACTUAL EXAM ALL
QUESTIONS AND 100% CORRECT ANSWERS
ALREADY GRADED A+|| LATEST AND COMPLETE
UPDATE 2024-2025 WITH VERIFIES SOLUTIONS||
ASSURED PASS!!!
Bleeding a power steering unit is generally done by
turning the steering wheel left and right repeatedly
After rounding a turn, the front wheels do not return to the straight ahead position
in a normal way. What adjustment is most likely to be out of specifications?
Caster
"Toe" adjustment on front wheel drive vehicles is made by:
changing he length of the steering linkage
When performing a front-end alignment what should you do before you adjust the
toe setting?
adjust the caster & camber
Front-wheel toe-in adjustment on rear-wheel drive vehicles is made by:
, 2|Pag e
changing the length of the steering linkage
A mechanic is going to adjust the curb height on a car with torsion bars. To do this
the car should be checked:
on a level surface with the car at curb weight
A proper way to check ball joints for wear is by:
visual observation of the wear indicator & unloading the ball joint and using a pry
bar and a dial indicator
which of the following adjustments can be made on all vehicles with MacPherson
strut suspensions?
Toe settings
You are checking the war on ball joints with a dial indicator at the wheel rim. What
must you do to get accurate readings?
check the wheel bearing adjustment and correct if needed
A mechanic jacks up a car, stands facing it, places a hand on the front of each tire.
The mechanic pushes out and then pulls in on both tires. Too much movement
would most likely mean that:
the tie rod ends are worn
