Telecom Tower Technician 1 Exam
|questions and answers | Verified
How often must a fire extinguisher be inspected by a qualified person? - ANSWER
Annually
What is a crown block? - ANSWER An upper sheave assembly on top of a structure
When using a fall restraint system, what is the minimum anchorage allowed?
- ANSWER 1000 lbs
When using a y-lanyard attached to your back d-ring, at what height should the
connection to your anchorage take place? - ANSWER Shoulder level or above
A company's health, safety and environment policy should be a combination of labor
regulation and ? - ANSWER Industry standards
How many pounds force is one kilo Newton? - ANSWER 225 lbs
Who is the third part group that approves and endorses standards? - ANSWER
American national standards institute (ANSI)
When tagging a load, who will tell you when to stop tagging? - ANSWER The capstan
operator and tower crew
The outer sheath of a synthetic endless sling is part of the slings strength - ANSWER
False
, What is the factor of Safety specified for rigging equipment - ANSWER 5:1
If a synthetic rope has a breaking strength of 7600 lbs, what is the maximum gross
load that can be lifted? - ANSWER 760lbs
An RF monitor should be worn in areas of unknown RF exposure - ANSWER True
What motion indicates lower the load? - ANSWER Point index finger towards
ground and make a circling motion with that finger
A hoist should be able to withstand a minimum of __________ ,the maximum intended
line pull - ANSWER 1.5 times
The operator and signal person should be familiar with what? - ANSWER Vernacular
used in the industry, industry hand signals, and industry standards
Where OSHA has not yet promulgated specific regulations, who is responsible for
ensuring the acts general clause is followed? - ANSWER Employer
All rigging equipment should be inspected daily before use - ANSWER True
On a job site, who should be involved in the JHA process? - ANSWER The whole crew
The person operating the capstan will need a clear view of what? - ANSWER The
load and signal person
All cranes must be inspected _________ by a competent person before use - ANSWER
Daily
Work boots with ankle support are recommended for all work sites - ANSWER True
|questions and answers | Verified
How often must a fire extinguisher be inspected by a qualified person? - ANSWER
Annually
What is a crown block? - ANSWER An upper sheave assembly on top of a structure
When using a fall restraint system, what is the minimum anchorage allowed?
- ANSWER 1000 lbs
When using a y-lanyard attached to your back d-ring, at what height should the
connection to your anchorage take place? - ANSWER Shoulder level or above
A company's health, safety and environment policy should be a combination of labor
regulation and ? - ANSWER Industry standards
How many pounds force is one kilo Newton? - ANSWER 225 lbs
Who is the third part group that approves and endorses standards? - ANSWER
American national standards institute (ANSI)
When tagging a load, who will tell you when to stop tagging? - ANSWER The capstan
operator and tower crew
The outer sheath of a synthetic endless sling is part of the slings strength - ANSWER
False
, What is the factor of Safety specified for rigging equipment - ANSWER 5:1
If a synthetic rope has a breaking strength of 7600 lbs, what is the maximum gross
load that can be lifted? - ANSWER 760lbs
An RF monitor should be worn in areas of unknown RF exposure - ANSWER True
What motion indicates lower the load? - ANSWER Point index finger towards
ground and make a circling motion with that finger
A hoist should be able to withstand a minimum of __________ ,the maximum intended
line pull - ANSWER 1.5 times
The operator and signal person should be familiar with what? - ANSWER Vernacular
used in the industry, industry hand signals, and industry standards
Where OSHA has not yet promulgated specific regulations, who is responsible for
ensuring the acts general clause is followed? - ANSWER Employer
All rigging equipment should be inspected daily before use - ANSWER True
On a job site, who should be involved in the JHA process? - ANSWER The whole crew
The person operating the capstan will need a clear view of what? - ANSWER The
load and signal person
All cranes must be inspected _________ by a competent person before use - ANSWER
Daily
Work boots with ankle support are recommended for all work sites - ANSWER True
