SHP - SMART HOME PRO FINAL EXAM
True - ANSWER The firefighter may be installed next to a stand-alone battery
smoke detector
False - ANSWER When performing a full system test, you may bypass any
open doors or windows
Always enable the emergency - ANSWER When programming a skey1, you
must
False - ANSWER When running power to the take345, polarity doesn't apply
Audible alarm (7) - ANSWER When programming the emergency key for the
skey1,which zone/sensor type is used.
True - ANSWER When installing a smkt3,you must use the included screws
and anchors
True - ANSWER When installing the firefighter, it is required to test the
customers existing smoke detectors
Between 6"(15cm) and 2'(61cm) from floor - ANSWER When installing a
Dw21, where is the approved location for the sensor
Provided double sided tape - ANSWER When installing a dw11 on a vinyl or
metal frame, what should primarily use to mount the sensor
, Beans & wire caps - ANSWER Which of the following materials could you
use to assemble more than one ground terminal in a takeover.
Smoke detector - ANSWER Which of the following sensors can you not
program with a translator
True - ANSWER During the installation of the take 345, you must always test
the new 12v battery before using it.
16.5 - ANSWER What is the output voltage of transformer used to power the
sky control
12" - ANSWER What is the minimum distance for placement of a co3 from
the corners of the wall
False - ANSWER The smkt3 has 2 function:smoke and heat detection
Loop 1 Zone 14 - ANSWER How would you program a co3 if mounted on a
hallway wall
Not true - ANSWER When adding a translator it is necessary to program all the
currently installed sensors as new devices on the panel
True - ANSWER Always install the dw21 in the door frame
(09) Smoke detector. (09) Heat detector. (08) Freeze - ANSWER Which of the
following zone/sensor types are correct when programming an smkt3
True - ANSWER The firefighter may be installed next to a stand-alone battery
smoke detector
False - ANSWER When performing a full system test, you may bypass any
open doors or windows
Always enable the emergency - ANSWER When programming a skey1, you
must
False - ANSWER When running power to the take345, polarity doesn't apply
Audible alarm (7) - ANSWER When programming the emergency key for the
skey1,which zone/sensor type is used.
True - ANSWER When installing a smkt3,you must use the included screws
and anchors
True - ANSWER When installing the firefighter, it is required to test the
customers existing smoke detectors
Between 6"(15cm) and 2'(61cm) from floor - ANSWER When installing a
Dw21, where is the approved location for the sensor
Provided double sided tape - ANSWER When installing a dw11 on a vinyl or
metal frame, what should primarily use to mount the sensor
, Beans & wire caps - ANSWER Which of the following materials could you
use to assemble more than one ground terminal in a takeover.
Smoke detector - ANSWER Which of the following sensors can you not
program with a translator
True - ANSWER During the installation of the take 345, you must always test
the new 12v battery before using it.
16.5 - ANSWER What is the output voltage of transformer used to power the
sky control
12" - ANSWER What is the minimum distance for placement of a co3 from
the corners of the wall
False - ANSWER The smkt3 has 2 function:smoke and heat detection
Loop 1 Zone 14 - ANSWER How would you program a co3 if mounted on a
hallway wall
Not true - ANSWER When adding a translator it is necessary to program all the
currently installed sensors as new devices on the panel
True - ANSWER Always install the dw21 in the door frame
(09) Smoke detector. (09) Heat detector. (08) Freeze - ANSWER Which of the
following zone/sensor types are correct when programming an smkt3
