, The unit of measurement for resistance is represented by the letter or symbol
_________. - CORRECT ANSWERS-Ohms
Voltage is represented by the letter or symbol ________. - CORRECT ANSWERS-E
Current is represented by the letter or symbol _______. - CORRECT ANSWERS-I
Power is represented by the letter or symbol _______. - CORRECT ANSWERS-P
Opposition to current flow is generally termed __________. - CORRECT ANSWERS-
resistance
Article _______ in the NEC distinguishes between an outlet and a receptacle. -
CORRECT ANSWERS-100
It is safer when using a wrench to adjust your stance and then______ on the wrench
handle. - CORRECT ANSWERS-pull
Which tools would be best to use to tighten the locknut/connector to the box?
I. linemans pliers and a flat blade screwdriver
II. Tongue and groove pliers - CORRECT ANSWERS-II
Improper torque can cause_____.
I. injury or death
II. Fasteners to prematurely wear or break
III. overheating of electrical terminals - CORRECT ANSWERS-all of the above
Single ladders longer than _____ feet should not be used. - CORRECT ANSWERS-30
feet
Code article ______ covers temporary wiring. - CORRECT ANSWERS-590
Look in the NEC Index and find uses permitted for AC cable. The code reference for this
is _______. - CORRECT ANSWERS-320.10
According to the NEC Index, branch circuits are covered under in Articles _____. -
CORRECT ANSWERS-210 and 220
Chapters 5,6, and 7 of the NEC relate to: - CORRECT ANSWERS-special occupancies
and conditions along with special equipment
A particular load is rated to use 2.2 KW at 240 volts this load is connected to a 2-pole
breaker in a panel using 12 AWG conductors. How much current will this load draw? -
CORRECT ANSWERS-9.2
_________. - CORRECT ANSWERS-Ohms
Voltage is represented by the letter or symbol ________. - CORRECT ANSWERS-E
Current is represented by the letter or symbol _______. - CORRECT ANSWERS-I
Power is represented by the letter or symbol _______. - CORRECT ANSWERS-P
Opposition to current flow is generally termed __________. - CORRECT ANSWERS-
resistance
Article _______ in the NEC distinguishes between an outlet and a receptacle. -
CORRECT ANSWERS-100
It is safer when using a wrench to adjust your stance and then______ on the wrench
handle. - CORRECT ANSWERS-pull
Which tools would be best to use to tighten the locknut/connector to the box?
I. linemans pliers and a flat blade screwdriver
II. Tongue and groove pliers - CORRECT ANSWERS-II
Improper torque can cause_____.
I. injury or death
II. Fasteners to prematurely wear or break
III. overheating of electrical terminals - CORRECT ANSWERS-all of the above
Single ladders longer than _____ feet should not be used. - CORRECT ANSWERS-30
feet
Code article ______ covers temporary wiring. - CORRECT ANSWERS-590
Look in the NEC Index and find uses permitted for AC cable. The code reference for this
is _______. - CORRECT ANSWERS-320.10
According to the NEC Index, branch circuits are covered under in Articles _____. -
CORRECT ANSWERS-210 and 220
Chapters 5,6, and 7 of the NEC relate to: - CORRECT ANSWERS-special occupancies
and conditions along with special equipment
A particular load is rated to use 2.2 KW at 240 volts this load is connected to a 2-pole
breaker in a panel using 12 AWG conductors. How much current will this load draw? -
CORRECT ANSWERS-9.2
