JCC Midterm Study Guide Questions With Complete
Solutions
How is power supplied to the HFIP Controller, HF Modem,
UHF Modem, and SNR Controller? Correct Answer -
PDA/UPS
Incoming RF Signals are converted into AF from what piece of
equipment? Correct Answer - Receiver
On the RCV side of TSN 5 KHz Circuit Diagram, RF is
transferred from the antenna to what two components bypassing
the WSC 3? Correct Answer - SA-2000
- SB-4267
The R-2368 instruction manual contains what two types of
information? Correct Answer - Technical Descriptions
- Detailed Programming Procedures
This process combines signals into one aggregated signal, what
is it called? Correct Answer - Multiplexing
To power on the TD-1271, you power on, then what button is
pressed? Correct Answer - BIT ALARM/RESET Button
What 3 resources are used to setup UHF DAMA TD-1271
SATCOM Circuit? Correct Answer - COMMPLAN
- COMMS Status Board
- SOP
, What antenna is used for DAMA TD-1271 SATCOM Voice and
Data? Correct Answer - OE-82C
What application allows shared information across the globe?
Correct Answer - CAS
What application deals with information about current global
forces? Correct Answer - GCCS-M
What are 2 characteristics of the HFRG Tx Subsystem? Correct
Answer - Contains Broadband and Narrowband Portions
- Combines signals and routes them to the antenna
What are 3 characteristics of Transceivers? Correct Answer -
LOS
- SATCOM
- Combination of Tx and Rx in one piece of equipment
What are 3 Networks found on Shore Side? Correct Answer -
NIPR
- SIPR
- TS/SCI
What are the 2 ways that show a COMMSPOT Report has been
received? Correct Answer - MSGID
- SUBJ Line
What are the 3 Key Operations performed by the UHF Modem
and SNR Controller? Correct Answer - Modulating and
Demodulating the Signal
- Providing a Network Bridge to allow IP connectivity
Solutions
How is power supplied to the HFIP Controller, HF Modem,
UHF Modem, and SNR Controller? Correct Answer -
PDA/UPS
Incoming RF Signals are converted into AF from what piece of
equipment? Correct Answer - Receiver
On the RCV side of TSN 5 KHz Circuit Diagram, RF is
transferred from the antenna to what two components bypassing
the WSC 3? Correct Answer - SA-2000
- SB-4267
The R-2368 instruction manual contains what two types of
information? Correct Answer - Technical Descriptions
- Detailed Programming Procedures
This process combines signals into one aggregated signal, what
is it called? Correct Answer - Multiplexing
To power on the TD-1271, you power on, then what button is
pressed? Correct Answer - BIT ALARM/RESET Button
What 3 resources are used to setup UHF DAMA TD-1271
SATCOM Circuit? Correct Answer - COMMPLAN
- COMMS Status Board
- SOP
, What antenna is used for DAMA TD-1271 SATCOM Voice and
Data? Correct Answer - OE-82C
What application allows shared information across the globe?
Correct Answer - CAS
What application deals with information about current global
forces? Correct Answer - GCCS-M
What are 2 characteristics of the HFRG Tx Subsystem? Correct
Answer - Contains Broadband and Narrowband Portions
- Combines signals and routes them to the antenna
What are 3 characteristics of Transceivers? Correct Answer -
LOS
- SATCOM
- Combination of Tx and Rx in one piece of equipment
What are 3 Networks found on Shore Side? Correct Answer -
NIPR
- SIPR
- TS/SCI
What are the 2 ways that show a COMMSPOT Report has been
received? Correct Answer - MSGID
- SUBJ Line
What are the 3 Key Operations performed by the UHF Modem
and SNR Controller? Correct Answer - Modulating and
Demodulating the Signal
- Providing a Network Bridge to allow IP connectivity
