Mopar Brake SERVICE POST TEST
Technician A states, if there is a loss of pressure in the brake's hydraulic system, it could be due to a
leak. Technician B states, If the brake pedal is applied and it has a spongy feel, there may be air in the
brake's hydraulic system. Who is correct? ✔️✔️Both A and B
When the brake pedal is applied, the master cylinder converts _______________pressure to
________________ pressure. ✔️✔️hydraulic, mechanical
Before reinstalling a floating brake caliper after performing a front brake service, it is important to
____________. ✔️✔️clean and lubricate the guide pins
After installing new shoes on the rear drum brakes, a quality check reveals that when the parking brake
is engaged the warning light appears, but the parking brakes don't hold. What would be the most likely
reason for this concern? ✔️✔️The parking brake is not properly adjusted
Technician A states, a plugged vacuum inlet on a vacuum powered brake booster would result in a hard
pedal complaint. Technician B states, hydraulic power assisted brake boosters can be tested using a
power steering analyzer. ✔️✔️Both A and B
Why do vehicles use a split brake circuit configuration? ✔️✔️To ensure at least two wheels retain
braking ability
The brake systems are split into two distribution circuits. Where does the split occur? ✔️✔️At the
master cylinder
A technician is replacing the front brakes on a customer's vehicle and notices the hoses and seals are
swollen. What could cause the concern? ✔️✔️Contaiminated brake fluid
A technician receives a vehicle with a parking brake looseness and failure to hold concern. Which of the
following is the most likely cause of this concern? ✔️✔️Stretch in the cable from normal usage
Technician A states, if there is a loss of pressure in the brake's hydraulic system, it could be due to a
leak. Technician B states, If the brake pedal is applied and it has a spongy feel, there may be air in the
brake's hydraulic system. Who is correct? ✔️✔️Both A and B
When the brake pedal is applied, the master cylinder converts _______________pressure to
________________ pressure. ✔️✔️hydraulic, mechanical
Before reinstalling a floating brake caliper after performing a front brake service, it is important to
____________. ✔️✔️clean and lubricate the guide pins
After installing new shoes on the rear drum brakes, a quality check reveals that when the parking brake
is engaged the warning light appears, but the parking brakes don't hold. What would be the most likely
reason for this concern? ✔️✔️The parking brake is not properly adjusted
Technician A states, a plugged vacuum inlet on a vacuum powered brake booster would result in a hard
pedal complaint. Technician B states, hydraulic power assisted brake boosters can be tested using a
power steering analyzer. ✔️✔️Both A and B
Why do vehicles use a split brake circuit configuration? ✔️✔️To ensure at least two wheels retain
braking ability
The brake systems are split into two distribution circuits. Where does the split occur? ✔️✔️At the
master cylinder
A technician is replacing the front brakes on a customer's vehicle and notices the hoses and seals are
swollen. What could cause the concern? ✔️✔️Contaiminated brake fluid
A technician receives a vehicle with a parking brake looseness and failure to hold concern. Which of the
following is the most likely cause of this concern? ✔️✔️Stretch in the cable from normal usage
