Carpentry Semester #2 DSA
What grit sandpaper would be used for finish sanding? - answer220 grit
Radial arm saw - answer6 inch margin of safety
When using jointer, the stock must be not less than... - answer12 inches
Which of the materials should not be cut with the reciprocating saw? - answerUnseen or
unidentifiable materials
Most drills are 1/4", 3/8" or 1/2" in size. The size is determined by... - answerThe
capacity of the chuck
The power planner is used primarily... - answeras a thickness planner
The size of a belt sander is determined by... - answerThe width and length of the belt
When ripping a narrow piece of stock on the table saw, always... - answerpush the
stock through with a push stick
Find the center of a room with the dimension of 8'- 7 1/4" - answer4'- 3 5/8"
A 4d finish nail is how long? - answer1 1/2"
Roofing nails, staples, and brads are sized by... - answerthe wire gauge
Driving a nail straight through one member and into another member is called... -
answerface nailing
_____ is not often used in quality finish applications. - answerclinching
_____ are the nails used most often for framing - answercommon nails
____ are usually coated with a chemical that resists rusting and makes the nail more
difficult to withdraw. - answerGalvanized nails
____ screws are made of stainless steel or are galvanized. - answerDeck screws
Which of the following is not a factor in specifying bolts? - answerradius
What grit sandpaper would be used for finish sanding? - answer220 grit
Radial arm saw - answer6 inch margin of safety
When using jointer, the stock must be not less than... - answer12 inches
Which of the materials should not be cut with the reciprocating saw? - answerUnseen or
unidentifiable materials
Most drills are 1/4", 3/8" or 1/2" in size. The size is determined by... - answerThe
capacity of the chuck
The power planner is used primarily... - answeras a thickness planner
The size of a belt sander is determined by... - answerThe width and length of the belt
When ripping a narrow piece of stock on the table saw, always... - answerpush the
stock through with a push stick
Find the center of a room with the dimension of 8'- 7 1/4" - answer4'- 3 5/8"
A 4d finish nail is how long? - answer1 1/2"
Roofing nails, staples, and brads are sized by... - answerthe wire gauge
Driving a nail straight through one member and into another member is called... -
answerface nailing
_____ is not often used in quality finish applications. - answerclinching
_____ are the nails used most often for framing - answercommon nails
____ are usually coated with a chemical that resists rusting and makes the nail more
difficult to withdraw. - answerGalvanized nails
____ screws are made of stainless steel or are galvanized. - answerDeck screws
Which of the following is not a factor in specifying bolts? - answerradius
