• Wrong document? Swap it for free
  • Written by students who passed
  • Immediately available after payment
  • Read online or as PDF
Sell
Where do you study
Your language
Document preview thumbnail
Preview 3 out of 26 pages
Exam (elaborations)

ASE A6 Electrical/Electronic Systems Updated 2024/2025 Questions and Answers 100% Correct.

Document preview thumbnail
Preview 3 out of 26 pages

Who is right? A. Technician A only B. Technician B only C. Both A and B D. Neither A or B - D. Total voltage in a series circuit is equal to the sum of the voltages across the separate resistances. Total current in a series circuit is the same throughout left sides. A vehicle's tum signals flash too slowly. Technician A claims that the condition could be caused by a faulty flasher. Technician B says that a bulb may be the wrong type. Who is right? A. Technician A only B. Technician B only C. Both A and B D. Neither A or B - .c Which of these should be used when soldering electrician wiring connections? A. rosin core flux B. acid core flux C. sulfur core flux D. none of the above - .a When testing computer-controlled systems, a digital multimeter should be used with an input impedance of at least: A. lOk ohmsB. lOOk ohms C. 1 megohm D. 10 megohms - .d When troubleshooting a slow drain on the battery, which if these diagnostic tools should be used? A. Ohmmeter B. Ammeter C. Voltmeter D. Test fight - .b The condition of a lead-acid battery is being checked. Technician A says to use a galvanometer. Technician B says to use a capacitive battery tester. Who is right? A. Technician A only B. Technician B only C. Both A and B D. Neither A or B - .b While testing a starting circuit on a 5.7L V8 engine, the technician finds that the engine cranks slowly. The starter current draw is 90 amps, and the battery voltage while cranking is 11 volts. What should the technician do next? A. Check for voltage drop of the starter motor circuit. B. Test the battery capacity. C. Replace the starter motor, as a short Is indicated. D. Determine the condition of the engine. - .aTechnician A says that a noisy alternator could be caused by a bad diode. Technician B says that a noisy alternator could be caused by a worn bearing. Who is right? A. Technician A only B. Technician B only C. Both A and B D. Neither A or B - .c An air bag system is being serviced, Technician A says to disconnect the yellow SRS connectors at the front of the vehicle. Technician B says to disconnect and isolate the negative battery cable. Who is right? A. Technician A only B. Technician B only C. Both A and B D. Neither A or B - .B The analog ohmmeter needle does not move when connected as shown above. (pg 82) This indicates that the rotor winding is: A. shorted B. grounded C. complete D. open - .d Technician A says a short circuit to ground in a circuit will decrease resistance. Technician B says a short circuit will Increase current flow.Who is right? A. Technician A only B. Technician B only C. Both A and B D. Neither A or B - .c

Content preview

ASE A6 Electrical/Electronic Systems
Who is right?

A. Technician A only

B. Technician B only

C. Both A and B

D. Neither A or B - D. Total voltage in a series circuit is equal to the sum of the voltages across the
separate resistances. Total current in a series circuit is the same throughout left sides.



A vehicle's tum signals flash too slowly. Technician A claims that the condition could be caused by a
faulty flasher. Technician B says that a bulb may be the wrong type.



Who is right?

A. Technician A only

B. Technician B only

C. Both A and B

D. Neither A or B - .c



Which of these should be used when soldering electrician wiring connections?



A. rosin core flux

B. acid core flux

C. sulfur core flux

D. none of the above - .a



When testing computer-controlled systems, a digital multimeter should be used with an input
impedance of at least:



A. lOk ohms

,B. lOOk ohms

C. 1 megohm

D. 10 megohms - .d



When troubleshooting a slow drain on the battery, which if these diagnostic tools should be used?



A. Ohmmeter

B. Ammeter

C. Voltmeter

D. Test fight - .b



The condition of a lead-acid battery is being checked. Technician A says to use a galvanometer.
Technician B says to use a capacitive battery tester.



Who is right?

A. Technician A only

B. Technician B only

C. Both A and B

D. Neither A or B - .b



While testing a starting circuit on a 5.7L V8 engine, the technician finds that the engine cranks slowly.
The

starter current draw is 90 amps, and the battery voltage while cranking is 11 volts. What should the
technician do next?



A. Check for voltage drop of the starter motor circuit.

B. Test the battery capacity.

C. Replace the starter motor, as a short Is indicated.

D. Determine the condition of the engine. - .a

, Technician A says that a noisy alternator could be caused by a bad diode. Technician B says that a noisy
alternator could be caused by a worn bearing.



Who is right?

A. Technician A only

B. Technician B only

C. Both A and B

D. Neither A or B - .c



An air bag system is being serviced, Technician A says to disconnect the yellow SRS connectors at the
front of the vehicle. Technician B says to disconnect and isolate the negative battery cable.



Who is right?

A. Technician A only

B. Technician B only

C. Both A and B

D. Neither A or B - .B



The analog ohmmeter needle does not move when connected as shown above. (pg 82) This indicates
that the rotor winding is:



A. shorted

B. grounded

C. complete

D. open - .d




Technician A says a short circuit to ground in a circuit will decrease resistance. Technician B says a short
circuit will Increase current flow.

Document information

Uploaded on
August 13, 2024
Number of pages
26
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers
$8.49

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
ACADEMICMATERIALS
4.0
(101)
Sold
629
Followers
185
Items
10503
Last sold
3 days ago




Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions