Machinist mate Exam
Terms in this set (521)
What NSTM deals with NSTM 231
propulsion and SSTG
Turbines?
Whats type of rotary pump Simple gear pimp
is frequently used as a
lubricanting pump on
pumpe and other aux
equipment?
What is the normal length 3"
of a tapered plug?
What is installed on a non- Combination exhaust relief valve 2-3 psi above exhaust
condensing turbone to line pressure
protect turbine casing from
excessive pressure?
On an SSTG, what protects Back pressure trip
turbine casing from
excessive pressure?
When starting an SSTG, 60 degrees
what is a minimum lube oil
temp?
What are the four sections Fundamentals, systems, watchstations, qual card
of a PQS?
What is the number for a 4790/7B
PMS feedback report?
When should oil coolers be When temp of lube oil leaving cooler is 100 degrees
put into operation on aux
machinery?
, DFT is designed to operate 15 psi and 240-250 degrees
at what pressure and temp?
What is installed on a Wearing rings
centrifugal pump to
eliminate renewing of an
entire propellor and pump
casing due to rapid wear?
The federal water pollution 1970
control act was amended in
what year?
What is the NSTM for 551
compressed air systems?
What is the max allowable 3%
pressure drop across a fuel
oil duplex strainer when
online?
What is the NSTM for 241
general reduction gear?
What is the NSTM for 554
forced draft blowers?
What is the required 10lbs per 1,000 gallons of feed water
amount of sodium nitrate
used for a sodium nitrate
wet lay up?
What is the NSTM for 635
insulation and lagging?
What is QA chapter 11? QA forms and instructions
What is QA chapter 12? Submarine preservation
What is QA chapter 13? Wire removal and replacement
What is QA chapter 10? Quality assurance records
What is QA chapter 9? Audits, surveillance, evaluations and assesments
Terms in this set (521)
What NSTM deals with NSTM 231
propulsion and SSTG
Turbines?
Whats type of rotary pump Simple gear pimp
is frequently used as a
lubricanting pump on
pumpe and other aux
equipment?
What is the normal length 3"
of a tapered plug?
What is installed on a non- Combination exhaust relief valve 2-3 psi above exhaust
condensing turbone to line pressure
protect turbine casing from
excessive pressure?
On an SSTG, what protects Back pressure trip
turbine casing from
excessive pressure?
When starting an SSTG, 60 degrees
what is a minimum lube oil
temp?
What are the four sections Fundamentals, systems, watchstations, qual card
of a PQS?
What is the number for a 4790/7B
PMS feedback report?
When should oil coolers be When temp of lube oil leaving cooler is 100 degrees
put into operation on aux
machinery?
, DFT is designed to operate 15 psi and 240-250 degrees
at what pressure and temp?
What is installed on a Wearing rings
centrifugal pump to
eliminate renewing of an
entire propellor and pump
casing due to rapid wear?
The federal water pollution 1970
control act was amended in
what year?
What is the NSTM for 551
compressed air systems?
What is the max allowable 3%
pressure drop across a fuel
oil duplex strainer when
online?
What is the NSTM for 241
general reduction gear?
What is the NSTM for 554
forced draft blowers?
What is the required 10lbs per 1,000 gallons of feed water
amount of sodium nitrate
used for a sodium nitrate
wet lay up?
What is the NSTM for 635
insulation and lagging?
What is QA chapter 11? QA forms and instructions
What is QA chapter 12? Submarine preservation
What is QA chapter 13? Wire removal and replacement
What is QA chapter 10? Quality assurance records
What is QA chapter 9? Audits, surveillance, evaluations and assesments
