Fanuc Section 3 – Handling Pro Study Guide Test.

Fanuc Section 3 – Handling Pro Study Guide Test. click on cycle start within the icon bar - CORRECT ANSWER To run and view a program from beginning to end utilizing the EOAT pick and place a part A) right click on the program within the cell browser and select run program B) from the test-run menu, select run panel C) right click on the robot and select run program D) click on cycle start within the icon bar allows you to drag the EOAT - CORRECT ANSWER What is the teach tool? A) allows you to drag the EOAT B) teaches the robot -similar to creating a program C) using the teach pendant, create a program D) using the teach pendant, jog the robot you must place a check in the 'allow part to be picked' and the in the 'allow part to be placed' found within the fixture simulation tab - CORRECT ANSWER For simulation to pickup and drop a part A) you must define a close gripper in the EOAT B) you must place a check in the 'allow part to be picked' and the in the 'allow part to be placed' found within the fixture simulation tab C) adjust the part to the tool center point D) you must place a check in the 'allow part to be picked' and in the 'allow part to be placed' within the properties page of the part click on the record button within the icon bar - CORRECT ANSWER To create an AVI file A) click on the record button within the icon bar B) from the tools menu select 'create an AVI file' C) from the robot menu select 'create an AVI file'