Aviation Knowledge
Which reports give wind in True North? - answer-METAR, TAF, ASOS, and the Winds and Temperatures Aloft Forecast (FD) Which reports give the wind in Mag North? - answer-Anything broadcast over FAA radios, AWOS and ASOS Cloud tops and bottoms on a PIREP are MSL or AGL? - answer-MSL Load factor is defined by: - answer-Lift over weight If maneuvering at the load factor limit, all of the following would result in exceeding the load factor Limit except? Increasing bank angle Increasing weight Increasing speed Increasing G - answer-Increasing speed The flight envelope of an aircraft is defined by which of the following? The minimum or maximum airspeed Pitch limit Fuel requirements All of the above - answer-All of the above Which of the following is not true concerning design maneuver speed Va? Va is not below the Turbulent Air Penetration Speed At any speed below Va the aircraft cannot be overstressed by normal flight control inputs The aircraft will stall at Va prior to reaching the limit load factor The aircrafts load limit factor will be reached at the highest possible speed - answer-The aircrafts load limit factor will be reached at the highest possible speed Which of the following is true concerning an aircraft limitation turbulent air penetration speed? Turbulent air penetration speed is designed for maximum passenger comfort Turbulent air penetration speed ensures aircraft controllability Flying at or below the turbulent air penetration speed ensures structural limitations The turbulent air penetration speed ensures adequate thrust is available - answer-Flying at or below the turbulent air penetration speed ensures structural limitations Which of the following is true concerning an aircraft in a stall? An aircraft stalls when there is a wide spread separation of the boundary layer from the upper wing surface An aircraft cannot be stalled in a dive An aircraft stall has no relationship to elevator/control column position An aircraft stall is directly related to the aircraft's speed - answer-An aircraft stalls when there is a wide spread separation of the boundary layer from the upper wing surface Which of the following is not a factor in producing a jet engine compressor stall? Engine thrust too low Bird strike or Foreign Object Damage High Cross Winds at high aircraft speeds Steady increase in engine thrust - answer-Bird strike or Foreign Object Damage Indicated Air Speed is determined by which of the following? Calibrated air pressure minus ram air pressure Ram air pressure minus static air pressure Ram air pressure minus ground speed Calibrated air pressure minus static air pressure - answer-Ram air pressure minus static air pressure Which of the following is true concerning Mach? Mach is the speed of an object divided by the speed of sound Mach will increase when temperature increases For a given speed, mach is constant with altitude Mach can only be determined for supersonic flight - answer-Mach is the speed of an object divided by the speed of sound Which of the following is the best answer concerning declaring minimum fuel? The pilot is declaring an emergency ATC will always give the aircraft priority handling The fuel condition upon arrival at destination warrants no undue delays The current fuel condition is below contingency fuel - answer-The fuel condition upon arrival at destination warrants no undue delays Clouds that form at high altitude and are composed of ice crystals are called what? - answer-Cirrus These clouds are often formed from mountain wave air flows and should be avoided. - answer-Lenticular Icing of the static ports can cause inaccurate readings in which instruments? - answer-Airspeed indicator Vertical speed indicator Altimeter How many seconds will it take to complete a standard rate turn of 120°? - answer-40 seconds (3° / second) In a slip the yawing moment is toward the ____________ of the turn. Turn radius will _____________ and turn rate will _____________. - answer-Outside, increase, decrease While in a descent from flight level 330 to 10,000 feet you are given the clearance to maintain mach .76 until you are able to transition to 330 KIAS. Which of the following statements is true? Transition from mach speeds to knots will happen at a higher altitude than if instructed to fly at 250 KIAS. Transition from mach speeds to knots will happen at a lower altitude than if instructed to fly at 250 KIAS
Document information
- Uploaded on
- July 1, 2024
- Number of pages
- 7
- Written in
- 2023/2024
- Type
- Exam (elaborations)
- Contains
- Questions & answers