Boilermaker test || A+ GRADED.

What do you do with a socket that has cracks correct answers Mark the socket with yellow paint and discard it immediately What is the tower man way used for correct answers To enter the tower internally The proper tightening sequence for a flange is a _______ pattern correct answers Cross bolting What wrench size do you use on 3/4 stud with heavy hex nuts correct answers 1-1/4 The fumes produced during welding upon which of the materials listed below pose a health hazard correct answers Galvanized , carbon steel, stainless steel During the air carbon arc cutting process , jets of compressed air are used to blow the slag away from the cuts area. Which are the potential hazards during this process correct answers Thermal burns, burning holes in compressed air line, burnt shoes and clothing When rigging valves , you should rig by the correct answers Body Where the hydrostatic testing goes correct answers Bottom with the tiny circle and cross in a middle 2 Where is the man way correct answers You enter in the hole-D Bonnet bell head correct answers The very top of the tower -8 When blinding a tower, what is the most preferred placement of the blinds correct answers At first flagnge of the tower, at the top of the tower, the easiest place to install them, or neither A ring type joint (RTJ) flange would be used in a correct answers High pressure pipe work system When hydro testing process equipment , where should the vent be located correct answers At the highest point allowed to relieve air pressure What should be done when performing a first line break correct answers Break away and down from you Pass partition correct answers Line in the middle of the bottom of the tower - 3 Channel head correct answers Right side of the tower lower -10 Tubes correct answers Middle of tower inside - 6 Davit correct answers Skinny tube on the right side - B Where are the bubble caps located correct answers On the tray rings