Fanuc pre-test
Turning the teach pendent on: - ANS-Gives motion control solely to the operator via the
TP
What must be accomplished to avoid hard-stops and over travels? - ANS-set axis limits.
SHIFT and the hard key COORD will display the following menu: - ANS-The jog menu.
SHIFT and POINT are needed to do what? - ANS-record the current position of the
robot
In the motion command "J P[2]100% FINE", if you wanted to tchange the "FINE"
component to a "CNT100" what buttons would you press? - ANS-select component,
then press [CHOICE]
To switch manually from one program to another, you have to be in which screen? -
ANS-select
How many robot I/O points are standard on a controller? - ANS-16
Which soft key is pressed to display the current motion instruction defaults from the
EDIT screen? - ANS-POINT
When creating a program, which hard key should be pressed? - ANS-Select
when using the prog adjust utility, which statement is correct? - ANS-pressing CLR_ADJ
or CLR_ALL will sae the current enabled data values.
Which of these tasks can be performed from the File menu? - ANS-get a directory of the
default device.
If while jogging the robot, you get an "In singularity' error, what must you do? - ANS-joint
jog J5 +/- at least 10 degrees.
The "Program Header Information" at the DETAIL softkey enables yu to modify the
following program information, except: - ANS-Activate Tool Frame.
Turning the teach pendent on: - ANS-Gives motion control solely to the operator via the
TP
What must be accomplished to avoid hard-stops and over travels? - ANS-set axis limits.
SHIFT and the hard key COORD will display the following menu: - ANS-The jog menu.
SHIFT and POINT are needed to do what? - ANS-record the current position of the
robot
In the motion command "J P[2]100% FINE", if you wanted to tchange the "FINE"
component to a "CNT100" what buttons would you press? - ANS-select component,
then press [CHOICE]
To switch manually from one program to another, you have to be in which screen? -
ANS-select
How many robot I/O points are standard on a controller? - ANS-16
Which soft key is pressed to display the current motion instruction defaults from the
EDIT screen? - ANS-POINT
When creating a program, which hard key should be pressed? - ANS-Select
when using the prog adjust utility, which statement is correct? - ANS-pressing CLR_ADJ
or CLR_ALL will sae the current enabled data values.
Which of these tasks can be performed from the File menu? - ANS-get a directory of the
default device.
If while jogging the robot, you get an "In singularity' error, what must you do? - ANS-joint
jog J5 +/- at least 10 degrees.
The "Program Header Information" at the DETAIL softkey enables yu to modify the
following program information, except: - ANS-Activate Tool Frame.
