FANUC Certification Exam 2024

FANUC Certification Exam 2024 Turning the Teach Pendant On: - ANSWER Gives motion control solely to the operator via the Teach Pendant What must be accomplished to avoid hard-stops and over-travels? - ANSWER Set Axis Limits SHIFT and the hardkey COORD will display the following menu: - ANSWER The "jog" menu SHIFT and POINT are needed to do what? - ANSWER Record the current position of the robot In the motion command "JP[2] 100% FINE", If you wanted to change the "FINE" component to a "CNT100" what buttons would you press? - ANSWER Select component, then press [CHOICE] To switch manually from one program to another, you have to be in which screen? - ANSWER Select How many Robot I/O points are standard on a controller? - ANSWER 16 Which soft key is pressed to display the current motion instruction defaults from the EDIT screen? - ANSWER POINT When creating a program, which hard key should be pressed? - ANSWER Select When using the Prog Adjust utility, which statement is correct? - ANSWER Pressing CLR_ADJ or CLR_ALL will save the current enabled data values Which of these tasks can be performed from the FILE menu? -