Ase Brakes Exam With Guaranteed Correct Answers

A - correct answer A drum is chattering on the brake lathe. This could be the result of: A. Failure to install the dampening belt. B. Cutting too slowly. C. Dull cutting blades. D. Cutting speed too fast. C - correct answer A vehicle is equipped with a hydro-boost brake system has a hard pedal with little braking action. Which of the following could be the cause? A. Low brake fluid B. Air in the brake fluid C. Low power steering fluid D. An overtightened power steering belt D - correct answer Which of the following could cause excessive noise while braking? A. Worn wheel cylinders B. Worn caliper pistons C. Seized caliper slides D. Missing clips C - correct answer A vehicle equipped with a "hill holding" option has an ABS code. Which tool would most likely be used to check the wheel speed sensor? A. AC volt meter B. Ohm meter C. Scan tool D. Ammeter C - correct answer The brake system has a soft, sinking pedal with the engine running. The brake fluid level is at the correct height. Which of the following could be the cause? A. A restricted vacuum hose B. A leaking master cylinder C. A bypassing master cylinder D. A stuck open vacuum check valve A - correct answer Technician A says a hydro-boost system can use the power steering pump to operate the booster. Technician B says a hydro-boost system can use engine vacuum to operate the booster. Who is correct? A. A B. B C. Both A and B D. Neither A nor B D - correct answer A disc brake caliper is dragging. All of the following could be the cause EXCEPT: A. Binding pins. B. Sticking piston. C. Binding caliper. D. Worn brake pads. A - correct answer The rear wheels of a front wheel drive car lockup during heaving breaking. Technician A sa