CWB Codes and Standards (Practice Test Questions)

CWB Codes and Standards (Practice Test Questions) The AWS D1.1 Structural Welding Code-Steel - includes welding procedure and performance qualification requirements The CSA is one organization accredited by the Standards Council of Canada for developing standards related to joining and inspection. Name another one. - Canadian General Standards Board (CGSB) Which Canadian standard includes ferrous and non-ferrous materials with notch toughness and includes aluminum piping systems? - CSA Z662 True or false: "Provisions for pre-qualified procedures are included in CSA W59.2 and AWS D1.2 standards/Codes for fabricating aluminum and its alloys". - False CSA S473 - includes a comprehensive fracture control plan. Most standards are created by: - voluntary efforts In Canada, shop inspections of pressure vessels are performed by: - an inspector employed by the regulatory authority in the province of fabrication. What are the three main categories of qualified personnel required by CSA W47.1 and CSA W47.2? - Welding Engineer, Welding Supervisor, Welder Which of the following codes/standards do not deal with fabrication, but include the qualification of welding procedures and welding personnel? - ASME Section IX T/F - AWS D17.1 was developed in part to replace MIL-STD-1595 and MIL-STD-2219. - True The function of standards can be said to: - Educate, simplify, certify and protect T/F - "Generally the word "shall" in a standard means that the user of the standard is obliged to satisfy the condition". - True CSA W59 allows for the use of what materials? - carbon steels and low-alloy steels Which code/standard does CSA B51 refer to for the qualification of welding procedures? - ASME IX The CAN/CSA Standard N285.6 Series covers the qualification and welding requirements for: - thin walled zirconium tubing T/F - CAN/CSA S473 introduces a Fracture Control Plan. - True AWS D1.1 does not allow for the pre-qualification of procedures welded with which of the following? - GMAW - Short Circuit and ESW T/F - "ASME IX is a design standard." - False The area(s) not covered by the ISO is (are) - electrical and electronic T/F - The Canadian Council of the International