Dante Level 1 Cert Test

Dante Level 1 Cert Test The Sample rate of an audio system dictates - the highest audio frequency that the system can handle What is LAN - a computer network that interconnects computers using a common range of IP Adresses what sample rates are supported by dante - 33.1kHz up to 192kHz Steps to deleting a subscription - 1. Open both transmitter and reciever to expose channels 2. click green checkmark at intersection of channels you wish to unsubscribe 3. wait for green checkmark to disappear do dante devices require special IP configurations - No, all commonly supported IP address methods are supported how are devices added to a dante network - devices are automatically discovered and displayed in the Controller in the dante controller routing tab, a green checkmark indicates - subscription successful as sample rate is increased on a device, what other property is usually changed - channel count is reduced the easiest way to get ip addresses for a functional stand alone dante netowrk is for all devices to - use the "obtain an IP address automatically" setting can dante use fiber instead of copper cables for ethernet? - yes are dante audio streams supported over wifi networks - no how are devices restored to a dane network after a power cycle - devices and connections are automatically restored how does dante interact with energy efficient ethernet (EEE) switches - EEE switches are not recommended for use with dante what is meant by a stand alone dante network - one that is not connected to the internet or to other networks what does the dante clock master do - provides synchronization for all dante devices on the network on a dante network latency is - deterministic, set per device what is the correct order of the steps to create a subscription in dante controller - 1. open the transmitter and receiver to expose channels of each 2. clock at the intersection of the two channels you wish to connect 3. wait for green checkmark to appear the names of the devices and channels in dante are - user definable and remembered by devices when should fiber be used for an ethernet connection - when runs over 100 m are required does dante require special networking cabling? - regular CAT5E ethernet cable is recommended, dante is built to run on standard IP networks, using standard ip equipment and cables dante works best with [blank] switches - Gigabit what is latency - latency is the audio signal delay in any audio system does a dante network require a special configuration for clocking - no, a clock master is always automatically elected by dante