U.S. Navy Aviation Support School Test 1 exam study guide questions fully solved & updated 2024

Natural Numbers a unit belonging to an abstract mathematical system Positive Numbers a unit ranging from zero to infinitiy Intergers numbers that are infinitely positive or negative Multiplication an abbreviated process of adding a series of numbers Division an abbreviated process of repeated subtraction of numbers What are the three types of fractions? Proper, Improper, and Mixed Number What are the two parts of a fraction? Numerator and Denominator Numerator indicates how many parts of the whole are being considered Denominator indicates how many parts of the whole were divided into What is the definition of Physics? science the deals with matter, force, motion, and energy How are the measurements that are used in Physics stated? all measurements are stated in standard units Matter any substance that has the properties of volume and mass What are the three states of matter? solid, liquid, and gas What are three common forms of energy release? heat energy, light energy, and sound energy What are the three methods of heat transfer? conduction, convection, and raditation What is the term used to measure mechanical power? Horsepower What is the term used to measure the amount of electrical power something has? Watts The ratio of output force to the input force determines a machines... mechanical advantage Energy the ability to perform work Potential Energy energy at rest within a body that, when released, will perform work Kinetic Energy energy in motion within a body that is performing work What are three types of basic machines? Lever, Wheels, and Gears A standard screw driver uses what type of screw-head? screws with a slot cut in the top Which screwdriver has a pointed tip? Reed and Prince What type of screwdriver would you use if there is not sufficient vertical clearance? Offset screwdriver What is the proper fit for a Phillips screwdriver head to the Phillips screw? Will fit completely with no overhang What type of wrench would you use to loosen or tighten in areas with restricted overhead clearance? Open-end wrench What is special about the nuts that require you to use a hook spanner wrench? Used on nuts that have slots cut into the sides What do you use to allow a ratchet to turn a nut or bolt with the handle held at an angle? Universal Joint What is the purpose of a scribe? to layout patterns and mark straight lines on hard surfaces What component of the MK-1 float coat do you need to use shear type electrical copper wire for? The inflation assembly actuation lever What striking tool would you use to drive another tool or to strike or mold metal? Rubber Mallet What are designed to transmit the turning force of a ratchet handle to the nut or bolt being removed or installed? Socket What type of punch is used for knocking out rivets after the heads have been chiseled off or freeing pins which are frozen in their holes? Drift Punch What does a proper flight deck uniform consist of? Cranial, Jersey, Steel-toe boots, goggles, gloves, and a float coat What color flight jersey does the catapult officer wear? Yellow Jersey What flight deck jersey color identifies personnel the deal with fuel? Purple Jersey What are the two types of mobile air conditioners? A/M32C-21 (electric) A/M32C- 17 (diesel) What is used to secure loose gear to the carrier deck or the ground? Wheel chocks and tie-down chains What is the nickname for the hydraulic servicing unit that can deliver a rated capacity of 20 GPM at 3500 PSI? Jenny What is the purpose of gas turbine power servicing equipment? To start aircraft, to provide and external source of power for ground operations, and to remove snow and ice from aircrafts Support Equipment any equipment used for handling, servicing, or maintenance of a weapon system such as an aircraft or for the towing of non self-propelled support equipment What are the types of maintenance platforms and their height ranges? B-1: 3-10 feet B-4A: 3-7 feet B-5A: 7-12 feet Electrostatic Discharge the transfer of electrostatic charge between bodies at different electrostatic potentials caused by direct contact or induced by an electrostatic field Which manual contains a description of the support equipment, and the instructions for their upkeep and repair? Maintenance Manuals