IFSTA 7th Edition Chapter 7: Ropes and Knots

IFSTA 7th Edition Chapter 7: Ropes and Knots 1. According to NFPA 1983, what must be used to make life safety rope? (277) [4.3.20] A. Sisal fibers B. Cotton fibers C. Block creel construction D. Braided rope construction - ANSWER C. Block creel construction 2. In order for life safety rope to be reused in life safety situations, it must NOT be: (278) [4.3.20] A. the same color as utility rope. B. exposed to heat or direct flame. C. made of block creel construction. D. stored in apparatus compartments. - ANSWER B. exposed to heat or direct flame. 3. Life safety rope must be removed from service if it has been: (278) [4.3.20] A. used for a water rescue. B. used more than ten times. C. subjected to an impact load. D. subjected to temperatures below freezing. - ANSWER C. subjected to an impact load. 4. At an emergency incident, utility rope can be used for: (278) [43.20] A. a rescue or hoisting operation . B. creating a control zone perimeter. C. rescuing a victim from swift water. D. supporting a firefighter who is rappelling. - ANSWER B. creating a control zone perimeter 5. What is one disadvantage of synthetic fiber rope? (279) [4.3.20] A. Must be replaced often B. Prone to mold and mildew C. Cannot support heavy loads D. Melts when exposed to heat - ANSWER D. Melts when exposed to heat 5. Synthetic fiber rope: (279) [4.3.20] A. is difficult to clean, inspect, and maintain. B. has a longer life span than natural fiber rope. C. is made from materials such as sisal or hemp. D. should not be used for life safety applications - ANSWER D. should not be used for life safety applications