Woodshop Safety Questions and Answers Rated A+

Woodshop Safety Questions and Answers Rated A+ What one must wear at all times working with any type of tool or machine safety goggles What is one thing not acceptable at any time while in the tech room messing around If one has long hair one should always pull it up or tuck it in If one doesn't feel comfortable operating one should ask for help _________ twice and ___________ once measure;cut __________ is cutting with the grain and ________ is cutting against the grain ripping;cross cutting Wait for the machine to come up to ___ before using speed Do not cut/drill too ___ fast Never leave tools or debris on the ___ table When cutting a long piece of wood always ask for ___ help When ripping a piece of wood on the table saw one should always use the ___ fence Never cut ___ on the table saw free hand one edge of the wood should be ___ before cutting jointed how high should the blade be above the wood on the table saw 1/4 to 1/2 One should always use the ___ on the table saw when ripping a piece of wood less than 3 inches push stick The smallest width you can cut on the table saw is ____ of an inch One and three fourths If a piece of wood starts to bind in the table saw while cutting you should ? stop the saw The radial arm saw general use is for _____ cross cutting a piece of wood Always keep your hands away from the __ area on the radial arm saw red Always make sure the pice of wood is firmly against the ___ on the radial arm saw fence Adjust the throat guard ___ of an inch on the band saw above the material 1/4 to 1/2 Always cut ___ cuts about 1/2" apart up to the pattern relief If the blade should break on the bandsaw turn the power ___ off Turn the machine __ if the blade is stuck and you can't work the piece to get the blade out off The smallest width you can through the jointer is __ of an inch 1 and 3/4 Material must be held down firmly against the ____ and against the ___ when jointing a piece of wood table;fence Don't interrupt a cut or try to back out of a cut bc the material can cause ___ kickback Always place a piece of scrap wood on the __ of the drill table Check and adjust the depth of the cut being drilled with the motor __ before drilling off Always hold the material being drilled firmly against the table of the __ to prevent the material from spinning pole The general purpose of the disk sander is to sand the __ of the wood not the __ of the wood edge;face