Dante Level 1 Questions and Answers Rated A

Dante Level 1 Questions and Answers Rated A Does Dante require special network cabling? Regular CAT5E or CAT6 Ethernet cable is recommended Dante uses ------- switches Standard What are the steps to create a subscription in Dante Controller? -Open the transmitter and receiver to expose channels of each -Click at the intersection of the two channels you wish to connect -Wait for green check mark to appear Dante works best with ------ switches gigabit As sample rate is increased on a device, what other property is usually changed? Channel count is reduced If Dante Controller is quit while audio is flowing on a Dante network, what happens? Nothing. Dante Controller is not required to be present for a Dante network to work. If a network is only used for Dante and has only one network switch, then: The network does not require a managed switch Is there any advantage to using automatic IP addressing on a Dante network? Yes. Automatic addressing ensures that devices create a working LAN. Does Dante support MIDI? No. Dante only transports audio data, and does not interfere with MIDI. The names of devices and channels in Dante are: User-definable and remembered by devices. The sample rate of an audio system dictates: The highest audio frequency that the system can handle The bit depth of an audio system dictates: The amplitude resolution of each sample What is meant by a "stand alone" Dante network? One that is not connected to the internet or to other networks A ----- network topology is the best practice for dante Star Dante use fiber instead of copper cable for Ethernet. Can How are devices added to a Dante network? Devices are automatically discovered and displayed in Dante Controller How are devices restored to a Dante network after power cycle? How are devices restored to a Dante network after power cycle? Dante is an example of an audio over IP (AoIP) solution On a Dante network, latency is: deterministic, set per device The default Dante latency of 1 millisecond is: very low and suitable for the majority of applications A gigabit connection can handle ----- channels of Dante audio at 48kHz sample rate and 24-bit depth. 512x512 A connection between Dante audio channels is called: a subscription What are the steps to delete a subscription in Dante Controller? -Open both transmitter and receiver to expose channels -Click green checkmark at intersection of channels you wish to unsubscribe -Wait for green checkmark to disappear How are device names used in Dante? Subscriptions are made from name to name What is a LAN? A computer network that interconnects computers using a common range of IP addresses Do Dante devices require special IP configuration? No, all commonly supported IP address methods are supported Does a Dante network require special configuration for clocking? No. A Clock Master is always automatically elected by Dante Dante transmitters are sources. Dante receivers are -------- Destinations The easiest way to get IP addresses for a functional stand-alone Dante network is for all devices and computers to: use the "obtain an IP Address Automatically" setting Audio sent over a Dante network is: uncompressed, bit-perfect What does the Dante Clock Master do? Provides synchronization for all Dante devices on the network Which of the following are diagnostic features of Dante Controller? (check all that apply) -Latency monitoring -Clock monitoring Approximately how much bandwidth is consumed by 64 channels of audio @ 48kHz/24 bit-depth, excluding network overhead? 74mbits/sec How does Dante interact with Energy Efficient Ethernet (EEE) switches? EEE switches are not recommended for use with Dante Where do Dante settings reside? On individual Dante devices What sample rates are supported by Dante? Dante supports most common sample rates, from 44.1kHz up to 192kHz What is latency? Latency is the audio signal delay in any audio system. When should fiber be used for an Ethernet connection? When runs over 100 meters are required.