NACE CIP 1 CBT Exam (Quizzes and Study Questions)

NACE CIP 1 CBT Exam (Quizzes and Study Questions) How is the process of steel corrosion ALWAYS described? - Correct answerelectrochemical Based on the galvanic series presented in the NACE CIP Level 1 Manual, which three can be used effectively as galvanic anodes for carbon steel? - Correct answer-zinc, aluminum, magnesium A decrease in temperature will generally cause the corrosion rate to _____ - Correct answer-decrease The electrolyte is a medium which carries the following type of current? - Correct answer-Ionic Corrosion occurring uniformly across a surface is called _____ - Correct answer-general corrosion When a conflict occurs on a coatings project, as the inspector, the preferred first course of action is to _____ - Correct answer-actively listen and endeavor to understand the positions of others A proper coating specification should contain information regarding ____, ____, and ____ - Correct answer-surface preparation standards, safety, and locations to be used Is it ever okay to accept a gift from a contractor? - Correct answer-NO What should you do if you find discrepancies between the specification and the coating manufacturer's technical data sheet? - Correct answer-seek written clarification from the owner's representative What are the general components of inspection reports? - Correct answer-- results of inspection tests - location(s) of work - details of preparation and application Inspection reports typically provide sufficient detail permitting the owner to evaluate ___ ___ ___ ___ - Correct answer-- contractor's performance - inspector's performance - job progress - work interruptions As an inspector headed to the job site for the first time, where would you always find instruction regarding appropriate types of PPE? - Correct answer-Safety Data Sheet (SDS), previously called MSDS Materials inventory report should contain which of the following? - Correct answer-- quantity of each component of each material onsite - material batch numbers - date of materials arrival at job site and storage information The primary function of the coating inspector is _____ - Correct answer-specification compliance High humidity in the air during coating application can cause _____ - Correct answersolvent entrapment The temperature at which moisture condenses on a surface is called _____ - Correct answer-dew point Where should the steel surface temperature reading be taken? - Correct answer-at the actual work location What type of water should be added to a sling psychrometer? - Correct answer-distilled Which type of coating is manufactured with the specific components added to slow down the activity of the electrochemical cell? - Correct answer-inhibitive Which coating component forms a stable film that retains its characteristic properties? - Correct answer-binder/resin A barrier coating interrupts the ______ of the electrochemical cell. - Correct answerelectrolyte List the three mechanisms by which coatings adhere to a substrate - Correct answer-1. Polar 2. Chemical 3. Mechanical What is the rule for coating work when it comes to Dew Point and Steel Temperature? - Correct answer-Steel Temperature must be 5 degrees less than the Dew Point What characteristics of solvents influence coatings? - Correct answer-- solvency power - volatility The contractor's sling psychrometer gives a different reading than your electric hygrometer. What would you do first as an inspector? - Correct answer-verify calibration of both instruments Which of the following coating are co-r