NEIEP 800 Final Questions and Answers(A+ Solution guide)

Hydro elevators in low rise applications do not need an _____ _____ room. - overhead machine Some advantages of hydros are lower equipment and building construction costs because the load of a hydro is carried to the _____ where as the load of a traction car is carried by the _____ _____. - ground, building structure When drilling the jack hole, the only proper way to determine if the hole is plumb is to remove the drill stem and bit and use a _____ _____. - Spider Bob To plumb the hole, a spider bob is attached to a length of piano wire suspended from as near as possible to the top of the _____ or from a fixed point on the drill rig. - Hoistway When welding a joint, lay _____ inch tack welds _____ degrees apart, shift it 90 degrees and lay two more 1 inch tack welds 180 degrees apart. - 1, 180 On power units having the motor beneath the tank, the pump may be either _____ driven or _____ coupled. - belt, direct The purpose of the _____/_____ is to silence the effect of any pulsations in the pump output and should be as close to the pump as possible. - silencer, muffler On Bolsters/Bolster Assembly, the plunger is fastened to the _____ _____ which is then mounted to the center of the Bolster Assembly. - platen plate With wye-delta, reduced current starting is accomplished without the need for _____. - resistors _____ run buttons should run the platform and sling at leveling speeds only. - TemporaryA _____ _____ consists of a piston held closed by an adjustable spring and must open at a certain pressure to prevent any further increase in pressure. - relief valve A _____ lowering valve allows the car to be lowered at a speed not exceeding 20fpm in case of power failure. - manual As the oil temperature changes, the _____ will change as well and will effect the performance, more specifically, the leveling and approach of the elevator. - viscosity Be sure wellways are properly _____ to avoid accidental injury to you, your team or anyone working outside of our industry. - barricaded Barricades around the wellway must be _____ inches high and be capable of withstanding a _____lb force. - 42, 200 A _____ protects you if you come in contact with a hot wire or component and then come in contact with ground. It opens the circuit and diverts the supplied current to ground. - GFCI A _____ _____ is useful for horizontal (side-to-side) pulling of the truss while being lowered into the wellway. - lever hoist