Nace Cip 1 Cbt Exam. Questions With 100% Correct Answers.

Which SSPC VIS 1 rust grade defines a surface covered with both mill scale and rust? ISO SA 2 1/2 is a blast cleaning standard that is similar to which joint standard? Approximately 75% of premature coating failures are caused by? NACE SP0178 comparator addresses which of the following? You are on a project where Testex tape is specified to determine surface profile by ASTM D4417 Method C. Which of the following is likely to cause reading errors? Which coating component forms a stable film that retains its characteristic properties? A barrier coating interrupts the of the electrochemical cell? Coatings adhere to a substrate by which of the following mechanisms? You are the Inspector on the job site. The air temperature is 84F (28C), your relative humidity is below 85% and your steel temperature is 79F (26C). Which of the following is the lowest acceptable dew point for coating work to continue? Which of the following characteristics of solvent influence coatings? The contractor's sling psychrometer gives a different reading than your electronic hygrometer. What would you do first as the inspector? Materials inventory report should contain which of the following? The primary function of the coating inspector is? High humidity in the air during coating application can cause? Steel surface temperature reading should be take? Which of the following would be appropriate to add to a sling psychrometer? Which type of coating is manufactured with specific components added to slow down the activity of the electrochemical cell(anode, cathode or both)? If a steel bridge is corroding in a mild environment, the corrosion process is defined as which of the following? Based on the galvanic series presented in the NACE CIP Level 1 Manual, which three materials are commonly used as galvanic anodes for carbon steel? A decrease in temperature will generally cause the corrosrion rate to? The electrolyte is a medium which carries the following type of current? Corrosion occurring uniformly across a surface is called? When conflict occurs on a coating project, as the Inspector, the preferred first course of action is to? A proper coating specification should contain information regarding which of the following? According to the NACE attestation, when is it OK to accept a gift from a contractor? What should you do if you find discrepancies between the specification and the coating manufacturers technical data sheet? Which of the following are generally components of the inspection reports? Inspection reports typically provide sufficient detail permitting the owner to evaluate? As an inspector headed to the joist for the first time, where would you always find instruction regarding appropriate types of The contractor should not use air blow off the surface of a coating if: When inspecting a silicone coating it is very important to: