Basic Firefighter Written Exam questions and answers latest top score.

Basic Firefighter Written Exam questions and answers latest top score. When using a rotary saw, start all cuts at rpm to prevent blades from binding into the material. - correct um is an example of a common prying tool. - correct gan An swinging door is indicated by the hinges being visible. - correct rd is an example of a pulling tool. - correct rock rake The and the are commonly paired together as "irons". - correct gan Flat head axe When breaking glass, stand , use the side of the tool and strike the of the pane. - correct -wind blunt/flat corner When getting a power tool from an apparatus for use on the fire ground, immediately the tool, after warming the tool, and then carry the tool to where it will be used. - correct turn off A is an example of a striking tool. - correct e hammer A is an example of a cutting tool. - correct rocating saw (Sawzall) When forcing entry through chained gates, you should cut the and not the lock. - correct What is the order of priorities when suppressing structure fires? - correct answers.1. protect exposures 2. cut off fire spread 3. attack seat of the fire When advancing a hose-line into a structure, extinguish any fire that is visible and . - correct sible A vehicle fire should be fought from a degree angle. - correct answers.45 If you are advancing an attack line into a structure and CANNOT see your feet, you should . - correct and are the appropriate hose sizes for attacking a structure fire. - correct answers.2 1/2 1 3/4 Directing fire streams toward the ceiling or wall of a room or building in order to generate large amount of steam is an attack. - correct ect At a structure fire, the highest priority are close priority fuel tanks and propane cylinders. - correct ures A attack is discharging water or foam directly onto a burning material. - correct t When extinguishing a container fire you should never approach from downhill or . - correct ind You should first direct your fire stream at the during a combination fire attack. - correct ng The process of hauling water from a fill site to a dump site is the definition of a . - correct shuttle hydrants are installed in areas where prolonged periods of subfreezing weather are common. - correct barrel The process of drawing water from a static source to supply a pumper is known as . - correct ing Wet-barrel hydrants are always filled with . - correct In the Matanuska-Susitna Borough, the type of fire apparatus that carries fol-da-tanks is . - correct rs What equipment is needed for drafting: - correct answers.1. hard suction 2. barrel strainer 3. low level strainer 4. float-a-dock 5. rubber mallet All collections must be air tight to obtain a when drafting. - correct m/suction The main valve is located ground on a dry-barrel hydrant. - correct List 3 alternative water supplies? - correct answers.1. lakes 2. rivers 3. underground tanks