OSHA 500 EXAM LATEST UPDATE 2023 / 2024 ACTUAL EXAM QUESTIONS AND ANSWERS GRADED A+

OSHA 500 EXAM LATEST UPDATE 2023 / 2024 ACTUAL EXAM QUESTIONS AND ANSWERS GRADED A+ The maximum amount of time an Authorized Outreach Trainer can teach in one day is: - ANSWERS-7 1/2 hours The 10-hour Construction Industry Outreach Training Program contains mandatory topic requirements which include "Introduction to OSHA" , "Personal Protective and Lifesaving Equipment " , "_______________________" and "Health Hazards in Construction." - ANSWERS-Focus Four Hazards (Falls, Electrocution, Stuck-By, and Caught-in or -Between) One of the objectives of the two-hour "Introduction to OSHA" topic is to inform workers of their rights . All of the following are worker rights under OSHA except for the right to: - ANSWERSBe compensated double their salary for overtime work By signing and dating the OSHA Outreach Training Program Report form, the trainer is: - ANSWERS-Certifying that he/she has conducted this outreach training class in accordance with the OSHA Outreach Training Program requirements and that the information on the form is true and correct Course learning objectives are: - ANSWERS-Specific statements defining measurable learner performance Some effective training techniques for reviewing content include, using role-plays, practice, analogies, technology, as well as: - ANSWERS-Using hands-on activities, games, memory aids, and case studies When developing effective electronic presentations using PowerPoint , you should use: - ANSWERS-Slides that are clear and concise, and with limited text Which of the following list best describes OSHA's inspection priorities? - ANSWERSImminent dander, fatality/catastrophe, complaints/referrals, programmed inspections Which of the following violations exists when an employer has demonstrated an intentional disregard for the requirements of the OSH Act or a plain indifference to employee safety and health? - ANSWERS-Willful A typical OSHA inspection includes which of the following onsite activities? - ANSWERS-Presentation of inspector credentials, opening conference, inspection walk around, closing conference This excerpt "each employer shall furnish to each of his employees employment and a place of employment which are free from recognized hazards that are causing or are likely to cause death or serious physical harm to his employees" is part of which of the following? - ANSWERS-General duty clause [5(a)(1)] of the OSH Act Which of the following best describes the legal intent of the Occupational Safety and Health Act of 1970? - ANSWERS-To eliminate or minimize on-the-job exposure to chemicals and safety hazards and protect the general public from environmental contamination The employer is responsible for insuring prompt medical attention in case of serious injury. What is required if no medical facility or physician is reasonably accessible? - ANSWERS-A person with valid first-aid training on the worksite and a willingness to render first aid Which of the following is an engineering noise control? - ANSWERS-All of the above (Substituting quieter equipment for existing equipment, Retrofitting existing equipment with damping materials, mufflers, or enclosures, Erecting barriers) Air contaminant hazards commonly found on construction sites include asbestos, silica, and: - ANSWERS-Lead According to the Hazard Communication Standard, when just employers communicate hazard information to employees? - ANSWERS-At the time of the employee's initial assignment and whenever a new physical or health hazard is introduced into their work area When steel erection contractors engage in multiple lift rigging, the maximum number of members. In a single lift must not exceed - ANSWERS-5 A leading cause of crane fatalities in contact with overhead power lines. What is the minimum safe clearance between a crane in use and energized power lines when the voltage is unknown? - ANSWERS-20 feet The possibility of being struck by a rotating crane is a serious potential hazard on a construction site. To prevent employees from entering these hazard areas, the employer must: - ANSWERS-Erect and maintain control lines, warning lines, railings or similar barriers to mark the boundaries of the hazard areas According to Subpart CC, during operations requiring signals, the ability to transmit signals between the operator and signal person must be maintained. If that ability is interrupted at any time, the operator: - ANSWERS-Must safely stop operations requiring signals until it is reestablished and a proper signal is given and understood Rigging equipment, including wire ropes, chains and slings must be inspected prior to use. Who is required to perform this inspection each day before the equipment is used? - ANSWERS-Competent person Special custom designed grabs, hooks, clamps and other lifting accessories must be marked to indicate the safe working loads. Also, they must be proof-tested prior to use to at least___________ percent of their rated load. - ANSWERS-125 What is the maximum number of broken wires allowed for wire rope slings used in construction? - ANSWERS-10% of the total wires in any 8 diameter section No employer shall use any motor vehicle equipment having an obstructed view to the rear unless the vehicle has a reverse signal alarm audible above the surrounding noise level or the vehicle is backed up only when: - ANSWERS-An observer signals that it is safe to do so