nicet level 1 | Questions and Answers with complete solution

rises or falls over 3 inches (NFPA 72, Table 14.4.3.2 17 (j) (4) - When testing a water level supervisory switch serving a pressure tank a signal shall indicate if the water level _____________from the required level the visible appliance (Nfpa 72 18.4.8.1) - If combination audible/visible appliances are installed the location of the installed appliance shall be determined by the requirements of 26 (Nec Annex C tables) - What is the maximum number of 12 gauge THHN wires that can be installed in 1" EMT 150 Ohms - Two resistors are connected in parallel. R1 = 300 Ohms, R2 = 300 Ohms. What is their equivalent resistance? 12 - A Room is 200' long and 150' wide and the 8' high ceiling is smooth and flat. A spot type heat detector has been selected that is listed for a 30' maximum spacing between detectors. According to NFPA 72 how many detectors will be needed to protect this room? NFPA 72 29.3.5 - Fire warning equipment to be installed in residential occupancies shall produce the audible emergency evacuation signal described in Two detectors or more on each initiating device circuit (NFPA 72 14.4.4.5.1) - According to NFPA 72 the minimum number of restorable fixed temperature spot type heat detectors that must be tested during each annual test is 6 - According to NFPA 72 how many spot type heat detectors are required for a space that is 80' long and 55 floor wide with a smooth 10' ceiling? the detector is listed for a maximum space between detectors of 30' White (NFPA 72, Table 17.6.2.1) - What color code requirement for a spot type heat detector rated at 200ﾟF10 years from the day-of manufacture. (NFPA 72, 14.4.7.1) - Unless otherwise recommended by the manufacturers published instructions single and multiple stations smoke alarms installed in one and 2 family dwellings shall be replaced every