CWEA Practice Test question and answer
Which welding process is most commonly used for SMALL pipe maintenance welding? - correct answersOxyAcetylene gas welding What is the proper definition of an engine? - correct answersIt is a machine designed to convert energy into useful mechanical motion What is wet stacking and how can it be prevented? - correct answersIt is unburned fuel collecting in the exhaust due to light or no load conditions To check flywheel face runout, where should the dial indicator be positioned? - correct answersThe base on the bell housing and pointer on the flywheel face If a 38-tooth gear running at 360 rmp is driving another gear at 144 rmp what is the number of teeth on the driven gear? - correct answers95 Which of the following is required for a sealed ball bearing? - correct answersIt does not need to be lubricated under normal use A DAFT is an acronym meaning: - correct answersDissolved Air Flotation Thickener What is the governing agency that permits odor control systems? - correct answersAQMD At what pressure rating would you use a blower instead of a fan? - correct answers7 psi Which of the following valves is unsuitable for high-pressure flow? - correct answersA needle valve A sodium hypochlorite tank's full working capacity is 23,000 gallons. Its current level is at 1,200 gallons. How many gallons does the delivery driver need to add to bring it to 70% capacity? - correct answers14,900 gal. What is the result if 6/8 " is converted to decimal form? - correct answers.75 What is the conversion of 100° Celsius into Fahrenheit? - correct answers212° If 17.32 v are applied across a resistance of 50 ohms, how much power is extended in the resistor? - correct answers6.0 watts A standard steel plate is 4' wide, 8' long, and 1' thick. If steel weighs 490 lbs/ft^3, what is the total weight of this plate? - correct answers1,306.6 lbs What is the volume in cubic feet of carbon media that is 6' thick in clarifier that has 50' diameter and is 20' deep? Round answer to the nearest cubic foot. - correct answers11,781 ft^3 A 150-watt, 120-volt lamp burns constantly for 8 hours at a rated voltage. What is the energy used in watts/hours? - correct answers1,200 watts/hours Which of the following is 12/16 of one inch equal to? - correct answers3/4 inch The property if an electrical circuit restricts the flow of current and: - correct answersresistance Which of the following can burn the insulation of the supply connections at the motor starter? - correct answersThe connections are loose or have poor contacts Where do you start troubleshooting when an electrical motor fails to operate after observing a mechanical failure? - correct answersAt the power source What does NEC stand for? - correct answersNational Electrical Code What is a pipe union typically used for? - correct answersIt is used to connect pipes Which of the following electrical circuits had more than one path for the current to flow? - correct answersParallel circuit Overloading of an electrical circuit may be caused by which of the following? - correct answersConnecting loads that draw too much current What type of current is stored in 9-volt battery? - correct answersDirect current What does GFI stand for? - correct answersGround Fault Interrupter What does EMT stand for? - correct answersElectrical Metal Tubing What device would be used to measure AC current flow in a large diameter conductor? - correct answersA clamp-on type ammeter What is the purpose of electrical interlock switches on panel doors? - correct answersTo interrupt local power for personal protections Which of the following actions should be taken before working on controls that may disrupt plant operations? - correct answersHave an operator present (this is not an action) What is the purpose of installing toe boards around the base where guard rails are placed along elevated work areas? - correct answersAs protection from tools or objects that may roll off What action is necessary before restarting rotating equipment that has recently undergone repair? - correct answersAll removed guards must be installed What is the main purpose of a confined space safety permit? - correct answersIt ensures the use of safety precautions and safe procedures The acronym "LOTO" is used to identify: - correct answersLock Out/Tag Out
Document information
- Uploaded on
- June 25, 2023
- Number of pages
- 6
- Written in
- 2022/2023
- Type
- Exam (elaborations)
- Contains
- Questions & answers