CA State Elevator Mechanic Study Guide Questions and answer 100% solved 2023

CA State Elevator Mechanic Study Guide Questions and answer 100% solved 2023Ladder must be installed if pit is deeper than... 35" (3') ASME A 17.1 - 2004 2.2.4.2 Ladder shall not extend more than ___ above the sill. 48" (4') ASME A 17.1 - 2004 2.2.4.2 Rungs (cleats or steps) of ladder should be a minimum of ___ wide. 16" ASME A 17.1 - 2004 2.2.4.2 Siderails shall have a clear distance of not less than ___ from their centerline to the nearest permanent object. 4.5" ASME A 17.1 - 2004 2.2.4.2 Ladder access shall not be permitted if pit is deeper than ___ below the sill of the access door. 120" (10') ASME A 17.1 - 2004 2.2.4.2 Illumination of pit and platform should be___. 10FC ASME A 17.1 - 2004 2.2.5.1 Where should the light switch be located in the pit? Where accessible from the pit access door. ASME A 17.1 - 2004 2.2.6.1 When the car is on compressed buffer, what is the clearance between the car and the pit? 24" (2') clearance. No part of the car should be touching the pit with a 24" (2') clearance. ASME A 17.1 - 2004 2.4.1.1 Where vertical clearances are less than ____", that area should be clearly marked on the pit floor. 24" (2') Markings should be___" diagonal red and white stripes "Danger low clearance." 4" When oil buffers are used, bottom runny should be no less than ___". 6" When spring or solid buffers are used, bottom runny should be no less than ___". 6" What is the maximum bottom runby on a car? 24" (2') Buffer data plate letters shall be no less than ___" in height. 1" What is the maximum bottom runby on a counterweight? 35" (3')