CYB-210 Project One Computer Network Modification Brief

CYB-210 Project One Computer Network Modification. Add free guest wireless internet for the customers  Install cameras that monitor the front desk and the waiting area.  Reconfigure the current network to support the new hardware. The needed hardware is already in the office, so the cameras and wireless router were harvested from the equipment closet. To get the network ready for the new hardware, the existing switch was reconfigured first. After selecting the switch and clicking on the CLI, a command was entered (see Figure 1) to add and name the new VLAN for the wireless router’s “Guest” network. The command was run again to add and name the new VLAN for the camera’s video network (see Figure 2). Figure 3 is the VLAN table showing both VLAN 70 and 80 have been added and the existing VLAN 50 and 150 are still configured. Next the wireless router was physically connected to the switch using a copper straight-through cable. It was plugged into FastEthernet0/7 on the router and Ethernet 1 on the wireless router. The FastEthernet0/7 port on the switch was assigned to VLAN 70 . This was done with the CLI on the switch (see Figure 4). Next, the wireless router needed to be configured. On the LAN option under the config tab of the router, the IP address was set to 192.168.70.10 (see Figure 5). Verified that the IP