CYB-210 week 6 Project One: Computer Networking Modification Brief

CYB-210 week 6 Project One: Computer Networking Modification Brief. This project consists of multiple items that need to be added as well as configured:  Add free guest wireless internet for the customers  Add tablet and smart phone to guest area  Install cameras that monitor the front desk and the waiting area.  Reconfigure the current network to support the new hardware. The needed hardware is already in the office, so the cameras and wireless router as well as the tablet and smart phone were gathered from the equipment closet. To start off the scenario I first got the network ready for the new hardware, by reconfiguring the existing switch. After selecting the switch and clicking on the CLI, a command was entered to add and name the new VLAN for the wireless router’s “Guest” network. The CLI was run again to add and name the new VLAN for the camera’s video network. Figure 3 is the VLAN table showing both VLAN 70 and 80 have been added and the existing VLAN 50 and 150 are still configured. Next the wireless router was physically connected to the switch using a copper straight-through cable. It was plugged into FastEthernet0/7 on the router and Ethernet 1 on the wireless router. The FastEthernet0/7 port on the switch was assigned to VLAN 70 . This was done with the CLI on the switch (see Figure 4). Next, the wireless router needed to be configured. On the LAN option under the config tab of the router, the IP address was set to 192.168.70.10 . I then verified that the IP configuration was set to DHCP on the internet option under the config tab of the router. The configuration was processed in the wireless section under the config tab. The SSID was labeled “Guest”, Both authentication and encryption type set to disabled. I completed the router configuration under the GUI tab. Verified that the internet connection type was set to DHCP, the router IP address was 192.168.70.10, the start IP address set to 192.168.70.101 and the maximum